Preparation and Sensitivity Study of Zinc Oxide (ZnO) Nanostructured Thin Films toward Acetone Gas: A Preliminary Experimental Study toward Non-Invasive Diabetes Diagnosis via Breath Analysis
مجلة العلوم الطبية و الصيدلانية · 15.06.2026 · 10 (2) · 41-50
DOI: 10.26389/ajsrp.d070426 ↗Kurz gefasst
Fachartikel in der Zeitschrift مجلة العلوم الطبية و الصيدلانية, erschienen am 15.06.2026. Verfasst von Sarab Ahmad Al-Mirdash und 2 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).
Themen: Diabetes mellitus
Abstract (Originalsprache)
Monitoring blood glucose levels is considered one of the important clinical challenges in the diagnosis of diabetes mellitus, as conventional methods are still based on invasive techniques that cause discomfort to patients and limit continuous monitoring. In this context, the analysis of acetone in exhaled breath has emerged as a promising non-invasive alternative, due to its direct correlation with metabolic processes associated with diabetes. However, many previously developed gas sensors still suffer from limitations such as high operating temperatures, poor selectivity, and insufficient long-term stability. This work aims to fabricate nanostructured zinc oxide (ZnO) thin films using the Spray Pyrolysis Deposition (SPD) technique and to investigate their sensing performance toward acetone gas at concentrations relevant to breath analysis, within the framework of developing non-invasive sensors for diabetes monitoring. ZnO thin films were deposited on glass substrates and subsequently annealed at 500 °C to improve their crystalline structure. The sensing performance was evaluated in a controlled test chamber using standard acetone gas at a concentration of 10 ppm, with all measurements repeated three times to ensure reliability and reproducibility. The results demonstrated a clear sensing response characterized by a decrease in electrical resistance upon exposure to acetone. The maximum sensitivity reached 173.02±2.02% at an operating temperature of 250 °C, which was identified as the optimum operating condition. In addition, the sensor exhibited a significantly higher response to acetone compared to water vapor (45.2±1.13%), indicating good selectivity even in the presence of humidity. Furthermore, the sensor showed stable and repeatable performance with only a slight decrease in response over time. It should be noted that all measurements were conducted under controlled laboratory conditions using standard acetone gas without the use of real human breath samples. Therefore, the present results demonstrate laboratory feasibility only. Future work will focus on investigating the detection limit and extending the concentration range, as well as evaluating the sensor performance in real breath samples for practical validation.
Zitieren
APA
Al-Mirdash, S. A., Al-Droubi, H. A., & Al-Baba, M. S. E. (2026). Preparation and Sensitivity Study of Zinc Oxide (ZnO) Nanostructured Thin Films toward Acetone Gas: A Preliminary Experimental Study toward Non-Invasive Diabetes Diagnosis via Breath Analysis. مجلة العلوم الطبية و الصيدلانية, 10(2), 41-50. https://doi.org/10.26389/ajsrp.d070426
Vancouver
Al-Mirdash SA, Al-Droubi HA, Al-Baba MSE. Preparation and Sensitivity Study of Zinc Oxide (ZnO) Nanostructured Thin Films toward Acetone Gas: A Preliminary Experimental Study toward Non-Invasive Diabetes Diagnosis via Breath Analysis. مجلة العلوم الطبية و الصيدلانية. 2026;10(2):41-50. doi:10.26389/ajsrp.d070426
BibTeX
@article{AlMirdash2026,
author = {Al-Mirdash, Sarab Ahmad and Al-Droubi, Huda AbdAlMohaimen and Al-Baba, Mohammed Samer Ehsan},
title = {Preparation and Sensitivity Study of Zinc Oxide (ZnO) Nanostructured Thin Films toward Acetone Gas: A Preliminary Experimental Study toward Non-Invasive Diabetes Diagnosis via Breath Analysis},
journal = {مجلة العلوم الطبية و الصيدلانية},
year = {2026},
volume = {10},
number = {2},
pages = {41--50},
doi = {10.26389/ajsrp.d070426}
}
EUVIMED