EUVIMEDEUVIMED entdecken
Crossref

Flame Stabilization Mode Transition Induced by Pilot Injection in a Cavity-Based Scramjet

Xu Zhang, Lianjie Yue, Dehai Yu, Qili Liu, Qifan Zhang

AIAA Journal · 2026-06 · 64 (6) · 3234-3245

DOI: 10.2514/1.j065899 ↗

Kurz gefasst

Fachartikel in der Zeitschrift AIAA Journal, 2026-06. Verfasst von Xu Zhang und 4 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 48 Literaturangaben. Gefördert von: Science Foundation for Young Scientists of State Key Laboratory of High Temperature Gas Dynamics, National Natural Science Foundation of China.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The effects of pilot hot gas injection on flame stabilization in a cavity-based scramjet were investigated using three-dimensional unsteady Reynolds-averaged Navier–Stokes simulations. Ethylene fuel was injected within a dual-solution regime exhibiting two possible flame stabilization modes. Pilot injection assisted both ignition and flame stabilization. Two representative pilot heating levels, low and high enough, were examined to assess their impact on flame behavior and mode transition. Results show that flame stabilization was highly sensitive to pilot heating power: low heating sustained cavity shear-layer stabilization, whereas high enough heating induced a transition to jet-wake stabilization. This transition was primarily driven by reduced ignition delay in the unburned jet-wake region due to elevated temperatures from pilot heating. Additionally, pilot injection enhanced fuel–air mixing through vortex generation. Both effects intensified with increasing pilot heating power. Consequently, high enough heating power facilitated upstream flame propagation and flow separation, ultimately triggering the transition. A theoretical analysis based on the Semenov thermal ignition theory further showed that high enough pilot heating promoted chemical heat release within a control volume in the unburned jet-wake region, which exceeded the enthalpy outflow in the initial cavity shear-layer stabilization mode. This energy imbalance led to a sustained temperature rise, initiating the transition.

Förderung

  • Science Foundation for Young Scientists of State Key Laboratory of High Temperature Gas Dynamics
  • National Natural Science Foundation of China

Zitieren

APA

Zhang, X., Yue, L., Yu, D., Liu, Q., & Zhang, Q. (2026). Flame Stabilization Mode Transition Induced by Pilot Injection in a Cavity-Based Scramjet. AIAA Journal, 64(6), 3234-3245. https://doi.org/10.2514/1.j065899

Vancouver

Zhang X, Yue L, Yu D, Liu Q, Zhang Q. Flame Stabilization Mode Transition Induced by Pilot Injection in a Cavity-Based Scramjet. AIAA Journal. 2026;64(6):3234-3245. doi:10.2514/1.j065899

BibTeX
@article{Zhang2026,
  author = {Zhang, Xu and Yue, Lianjie and Yu, Dehai and Liu, Qili and Zhang, Qifan},
  title = {Flame Stabilization Mode Transition Induced by Pilot Injection in a Cavity-Based Scramjet},
  journal = {AIAA Journal},
  year = {2026},
  volume = {64},
  number = {6},
  pages = {3234--3245},
  doi = {10.2514/1.j065899}
}
Kostenlos starten →