EUVIMEDEUVIMED entdecken
Crossref

Rheological, Ballistic, and Mechanical Properties of 3D Printed, Photocured Composite Propellants

Justin Lajoie, Jacob Blocker, Travis Sippel

Journal of Propulsion and Power · 2023-11 · 39 (6) · 936-944

DOI: 10.2514/1.b39113 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Propulsion and Power, 2023-11. Verfasst von Justin Lajoie und 2 weiteren Autor:innen. Die Arbeit wurde bisher 20-mal zitiert (Crossref) und nennt 52 Literaturangaben. Gefördert von: Air Force Office of Scientific Research.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study explores the rheological, mechanical, and ballistic properties of printed ammonium perchlorate composite propellant at 82.5% solids loading with binders curable with ultraviolet light of wavelength from 215 to 400 nm (UV). A polybutadiene urethane acrylate and two polyester urethane acrylate propellants are printed by an in-house-fabricated fused deposition molding printer. Propellants are all shear-thinning and have significantly lower viscosity than similar hydroxyl-terminated polybutadiene (HTPB) propellants. Uniaxial stress–strain measurements indicate that ultimate tensile strength and ultimate tensile strain of all photocurable propellants are found to be greater than HTPB propellant. In particular, the ultimate tensile strain of polyester urethane acrylate propellant is six times that of HTPB propellant, demonstrating high compliance. Ballistic properties are measured from combustion of printed propellant articles in a windowed Crawford combustion bomb at inert gas pressures of up to 12.1 MPa. The burning characteristics were found to be relatively planar, though strong burning rate anisotropy, expected as a result of print layer inhomogeneities, was observed in two of the three formulations. Overall, pressure exponents of the propellants were mild and ranged from 0.17 to 0.33. These results are compared and contrasted to those of other printed propellants. These results provide valuable insight into the selection of a safe binder system for printing of photocurable composite propellants.

Förderung

  • Air Force Office of Scientific Research

Zitieren

APA

Lajoie, J., Blocker, J., & Sippel, T. (2023). Rheological, Ballistic, and Mechanical Properties of 3D Printed, Photocured Composite Propellants. Journal of Propulsion and Power, 39(6), 936-944. https://doi.org/10.2514/1.b39113

Vancouver

Lajoie J, Blocker J, Sippel T. Rheological, Ballistic, and Mechanical Properties of 3D Printed, Photocured Composite Propellants. Journal of Propulsion and Power. 2023;39(6):936-944. doi:10.2514/1.b39113

BibTeX
@article{Lajoie2023,
  author = {Lajoie, Justin and Blocker, Jacob and Sippel, Travis},
  title = {Rheological, Ballistic, and Mechanical Properties of 3D Printed, Photocured Composite Propellants},
  journal = {Journal of Propulsion and Power},
  year = {2023},
  volume = {39},
  number = {6},
  pages = {936--944},
  doi = {10.2514/1.b39113}
}
Kostenlos starten →