EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

A Miniaturized 5.8 GHz L-Shaped Antenna Structure Modelled with Doubler-Multiplier Circuit Topologies

Saad G. Muttlak, Omar S. Abdulwahid, Mohammadreza Sadeghi, Mohamed Missous

Tikrit Journal of Engineering Sciences · 15.10.2026 · 33 (3) · 1-11

DOI: 10.25130/tjes.33.3.1 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Tikrit Journal of Engineering Sciences, online erschienen am 15.10.2026. Verfasst von Saad G. Muttlak und 3 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This work reports the design and performance of two 5.8 GHz rectenna circuits for energy harvesting in implanted medical devices. The miniaturization technique used in the present work yields a compact L-shaped antenna of only 5 mm2, making it highly compatible with non-surgical implantation inside the human body. The fabrication and simulation data of the antenna are well-matched, with strong performance compared with the reported structure at a similar frequency band. A -20 dB measured reflection, and -14.6 dB simulated peak gain at 5.5 GHz were obtained. The modeling results indicate that the proposed rectenna based on the Cockcroft-Walton voltage doubler produced an output voltage of 0.83 V, corresponding to an RF-to-DC conversion efficiency of 0.14% at 0 dBm RF power. Before modelling procedure, all the passive elements utilized in the rectenna configuration were fabricated and tested. A variation in the load resistor revealed that a rectenna with an integrated Dickson voltage multiplier delivered an optimum output voltage and power of 1.25 V and 5.5 µW at a 0.25 MΩ load, respectively. The Dickson voltage multiplier achieved a 0.55% conversion efficiency, matching the reported figure of merit in the literature. At a higher efficiency of 0.8% with a relatively low load, the results demonstrate the proposed topology's potential as a good candidate for a miniaturized integrated rectenna geometry utilized in high-frequency energy harvesting systems.

Zitieren

APA

Muttlak, S. G., Abdulwahid, O. S., Sadeghi, M., & Missous, M. (2026). A Miniaturized 5.8 GHz L-Shaped Antenna Structure Modelled with Doubler-Multiplier Circuit Topologies. Tikrit Journal of Engineering Sciences, 33(3), 1-11. https://doi.org/10.25130/tjes.33.3.1

Vancouver

Muttlak SG, Abdulwahid OS, Sadeghi M, Missous M. A Miniaturized 5.8 GHz L-Shaped Antenna Structure Modelled with Doubler-Multiplier Circuit Topologies. Tikrit Journal of Engineering Sciences. 2026;33(3):1-11. doi:10.25130/tjes.33.3.1

BibTeX
@article{Muttlak2026,
  author = {Muttlak, Saad G. and Abdulwahid, Omar S. and Sadeghi, Mohammadreza and Missous, Mohamed},
  title = {A Miniaturized 5.8 GHz L-Shaped Antenna Structure Modelled with Doubler-Multiplier Circuit Topologies},
  journal = {Tikrit Journal of Engineering Sciences},
  year = {2026},
  volume = {33},
  number = {3},
  pages = {1--11},
  doi = {10.25130/tjes.33.3.1}
}
Kostenlos starten →