EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC 4.0

An Approach to Design a Prototype of Lattice Structures: a Preliminary Study

Wiktoria Wojnicz, Keyru Salia Suraj

Management and Production Engineering Review · 02.07.2026 · 17 (2)

DOI: 10.24425/mper.2026.1326 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Management and Production Engineering Review, online erschienen am 02.07.2026. Verfasst von Wiktoria Wojnicz und 1 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper investigates the mechanical response of lattice cells based on numerical models and 3Dprinted specimens. Considering the growing interest in the application of lattice structures in engineeringand biomedical research, the design of lattice structures is becoming one of the key areas of modernmaterials engineering. The goal of this study is to develop author lattice cells that can be used in porousimplants maintaining external compression loading. In the scope of this study, four author lattice cellswere designed and produced from Acrylonitrile Butadiene Styrene (ABS) material using Zortrax M200and Bambu Lab A1 3D printers (fused deposition modelling (FDM) technology) without using anysupporting materials. A uniaxial compression test was performed using Zwick/Roell Z020. A numericalanalysis of proposed lattice cells was conducted in FEBio and Abaqus. Young's moduli of all testedlattice cells were assessed from experimental and numerical data along with relative errors. The Young’smodulus was identified in the range: the smallest was 14.24 MPa (experimental) with 27.00/25.00 MPa(numerical) and the largest was 571.33 MPa (experimental) with 611.69/641.27 MPa (numerical). Thisstudy presents a validated numerical-experimental protocol that can be applied to produce FDM-printedlattice cell structures through closed iteration approach by considering given requirements along withtechnological limitations of FDM printings (manufacturing-induced flaws, staircase effects, and anisotropicpolymer layer-bonding effects). Presented findings reveal that the designed topologies of latticecells depend on the resolution of used 3D printers, however proposed numerical-experimental protocoloffers a low-cost promising pathway for the early-stage design of patient-specific bone tissue implants.

Zitieren

APA

Wojnicz, W., & Suraj, K. S. (2026). An Approach to Design a Prototype of Lattice Structures: a Preliminary Study. Management and Production Engineering Review, 17(2). https://doi.org/10.24425/mper.2026.1326

Vancouver

Wojnicz W, Suraj KS. An Approach to Design a Prototype of Lattice Structures: a Preliminary Study. Management and Production Engineering Review. 2026;17(2). doi:10.24425/mper.2026.1326

BibTeX
@article{Wojnicz2026,
  author = {Wojnicz, Wiktoria and Suraj, Keyru Salia},
  title = {An Approach to Design a Prototype of Lattice Structures: a Preliminary Study},
  journal = {Management and Production Engineering Review},
  year = {2026},
  volume = {17},
  number = {2},
  doi = {10.24425/mper.2026.1326}
}
Kostenlos starten →