EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Assessment of the feasibility of a semi-monolithic GaN VCSEL structure emitting at 450 nm based on electrical and thermal modeling

Robert P. Sarzała, Dominika Dąbrówka, Hanna Sadzewicz

Bulletin of the Polish Academy of Sciences Technical Sciences · 03.11.2026 · 74 (6) · 6244

DOI: 10.24425/bpasts.2026.6244 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Bulletin of the Polish Academy of Sciences Technical Sciences, online erschienen am 03.11.2026. Verfasst von Robert P. Sarzała und 2 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This work presents a possible structure of a semi-monolithic GaN-based VCSEL with a tunnel junction, emitting at 450 nm and incorporating a nanoporous GaN (NP-GaN)/GaN distributed Bragg reflector (DBR). Self-consistent electrothermal simulations were performed to examine how the current-aperture radius and cavity length affect current-crowding and self-heating within the active region. Increasing the cavity length from 1𝜆 to 10𝜆 was found to markedly improve current uniformity and heat dissipation, while smaller apertures yielded lower maximum temperatures; a cavity length of 5𝜆 combined with a 3 μm aperture radius was identified as the optimal design compromise. The influence of NP-GaN porosity on the thermal resistance of the rear DBR was further analyzed for two refractive-index models, linear and quadratic, while maintaining a target reflectivity above 99.98%. A porosity of about 30% offered the best trade-off between the number of required DBR pairs and thermal performance, giving a maximum device temperature of 317.1–317.6 K. Comparison with alternative AlInN/GaN and AlScN/GaN DBRs showed that the NP-GaN/GaN mirror achieves the lowest maximum temperature and requires fewer layer pairs, despite the technological challenges of controlling nanoporosity precisely. These findings provide guidance for designing thermally efficient, high-reflectivity DBRs for future GaN-based VCSELs.

Zitieren

APA

Sarzała, R. P., Dąbrówka, D., & Sadzewicz, H. (2026). Assessment of the feasibility of a semi-monolithic GaN VCSEL structure emitting at 450 nm based on electrical and thermal modeling. Bulletin of the Polish Academy of Sciences Technical Sciences, 74(6), 6244. https://doi.org/10.24425/bpasts.2026.6244

Vancouver

Sarzała RP, Dąbrówka D, Sadzewicz H. Assessment of the feasibility of a semi-monolithic GaN VCSEL structure emitting at 450 nm based on electrical and thermal modeling. Bulletin of the Polish Academy of Sciences Technical Sciences. 2026;74(6):6244. doi:10.24425/bpasts.2026.6244

BibTeX
@article{Sarzaa2026,
  author = {Sarzała, Robert P. and Dąbrówka, Dominika and Sadzewicz, Hanna},
  title = {Assessment of the feasibility of a semi-monolithic GaN VCSEL structure emitting at 450 nm based on electrical and thermal modeling},
  journal = {Bulletin of the Polish Academy of Sciences Technical Sciences},
  year = {2026},
  volume = {74},
  number = {6},
  pages = {6244},
  doi = {10.24425/bpasts.2026.6244}
}
Kostenlos starten →