EUVIMEDEUVIMED entdecken
Crossref

Determination of an axial gas cyclone separator cut-off point by CFD numerical modeling

Arkadiusz Ryfa, Mieszko Tokarski, Wojciech Adamczyk, Adam Klimanek, Paweł Bargiel, Ryszard Białecki, Michał Kocot, Harald Kania, Janusz Stecko, Marianna Czaplicka

Archives of Thermodynamics · 29.04.2024 · 535-562

DOI: 10.24425/ather.2023.149733 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Archives of Thermodynamics, online erschienen am 29.04.2024. Verfasst von Arkadiusz Ryfa und 9 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper deals with the numerical simulation of a pilot-scale axial cyclone separator. The main purpose of this paper is to develop a numerical model that is able to foresee the cyclone separator cut-off point. This is crucial in blast furnace gas installation to capture large particles containing carbon and iron, while allowing smaller particles such as zinc and lead to pass through. The cut-off point must be designed to give a sufficiently high zinc and lead content in the sludge created after the second cleaning stage. This allows the sludge to become a commercial product. To design this cut-off point, an investigation of the influence of inlet gas velocity, temperature, and the angle of guiding vanes at the inlet was done. The developed CFD model was validated against experimental data on the fractional efficiency of the cyclone separator. The results were in good agreement with the experimental data for all parameters tested. The behavior of the particles inside the cyclone was also physically correct.

Zitieren

APA

Ryfa, A., Tokarski, M., Adamczyk, W., Klimanek, A., Bargiel, P., Białecki, R., Kocot, M., Kania, H., Stecko, J., & Czaplicka, M. (2024). Determination of an axial gas cyclone separator cut-off point by CFD numerical modeling. Archives of Thermodynamics, 535-562. https://doi.org/10.24425/ather.2023.149733

Vancouver

Ryfa A, Tokarski M, Adamczyk W, Klimanek A, Bargiel P, Białecki R, et al. Determination of an axial gas cyclone separator cut-off point by CFD numerical modeling. Archives of Thermodynamics. 2024:535-562. doi:10.24425/ather.2023.149733

BibTeX
@article{Ryfa2024,
  author = {Ryfa, Arkadiusz and Tokarski, Mieszko and Adamczyk, Wojciech and Klimanek, Adam and Bargiel, Paweł and Białecki, Ryszard and Kocot, Michał and Kania, Harald and Stecko, Janusz and Czaplicka, Marianna},
  title = {Determination of an axial gas cyclone separator cut-off point by CFD numerical modeling},
  journal = {Archives of Thermodynamics},
  year = {2024},
  pages = {535--562},
  doi = {10.24425/ather.2023.149733}
}
Kostenlos starten →