Analysis of the Influence of Tool Modifications on the Single-Point Incremental Forming Process of CP-Ti Gr 2 and Ti-6Al-4V Titanium Sheets
Archives of Metallurgy and Materials · 23.03.2026 · 75-82
DOI: 10.24425/amm.2026.157771 ↗Kurz gefasst
Fachartikel in der Zeitschrift Archives of Metallurgy and Materials, online erschienen am 23.03.2026. Verfasst von M. Szpunar und 2 weiteren Autor:innen.
Abstract (Originalsprache)
This study focuses on the influence of modifications of the material and geometry of the forming tool on the process of single-point incremental forming of titanium sheets CP-Ti Gr 2 and Ti-6Al-4V. The aim of the research was to analyze the influence of variants of the tool material and modifications of the geometry in the form of grooves with different arrangements on the forming process and the quality of the obtained drawpieces. Additionally, the influence of lubricant type and the heating method on the efficiency of the process was examined. Forming CP-Ti Gr 2 sheets using lubrication grooves on the tools did not contribute to the surface roughness and deformation improvement of the drawpieces. The most favorable results for CP-Ti Gr 2 sheet were obtained using a tool made of Al2O3 ceramics reinforced with SiC whiskers, warming with heating oil and lubrication with rape-seed oil. In the case of Ti-6Al-4V sheets, it was found that the uncoated carbide tool allowed for the greatest deformation of the drawpiece compared to the tools coated with different coatings and whisker-reinforced ceramics. The use of coatings did not have a positive effect on the process in terms of the coefficient of friction, tool wear and the drawpiece deformation. The conducted studies allow for a better understanding of the relationship between tool modification and the efficiency of the single-point forming process of titanium sheets and the quality of the obtained drawpieces.
Zitieren
APA
Szpunar, M., Ostrowski, R., & Trzepieciński, T. (2026). Analysis of the Influence of Tool Modifications on the Single-Point Incremental Forming Process of CP-Ti Gr 2 and Ti-6Al-4V Titanium Sheets. Archives of Metallurgy and Materials, 75-82. https://doi.org/10.24425/amm.2026.157771
Vancouver
Szpunar M, Ostrowski R, Trzepieciński T. Analysis of the Influence of Tool Modifications on the Single-Point Incremental Forming Process of CP-Ti Gr 2 and Ti-6Al-4V Titanium Sheets. Archives of Metallurgy and Materials. 2026:75-82. doi:10.24425/amm.2026.157771
BibTeX
@article{Szpunar2026,
author = {Szpunar, M. and Ostrowski, R. and Trzepieciński, T.},
title = {Analysis of the Influence of Tool Modifications on the Single-Point Incremental Forming Process of CP-Ti Gr 2 and Ti-6Al-4V Titanium Sheets},
journal = {Archives of Metallurgy and Materials},
year = {2026},
pages = {75--82},
doi = {10.24425/amm.2026.157771}
}
EUVIMED