EUVIMEDEUVIMED entdecken
Crossref

Research and simulation of the machining process of difficult-to-cut materials

Vadym Stupnytskyy, She Xianning

Ukrainian Journal of Mechanical Engineering and Materials Science · 2020 · 6 (3-4) · 41-50

DOI: 10.23939/ujmems2020.03-04.041 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Ukrainian Journal of Mechanical Engineering and Materials Science, 2020. Verfasst von Vadym Stupnytskyy und 1 weiteren Autor:innen. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 14 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Heat-resistant and high-alloy steels and alloys are difficult materials to machine. Optimizing the cutting parameters for such materials is a complex and multi-factorial technological process planning task. The paper describes the method of analysis of loading, thermodynamic and stress-strain state of a workpiece while cutting of typical representative of hard-to-cut materials (chromium-nickel alloy IN718) using finite element simulation. Influence of feed rate on cutting force and temperature in the zone of chip formation is given. The paper also analyzes the effect of cutting edge geometry on the thermal and stress state of the workpiece during cutting. Based on the conclusions about the simulation results, an analogy can be made with the processing of such materials. This will significantly reduce the time of technological preparation and decrease the cost of experimental studies.

Zitieren

APA

Stupnytskyy, V., & Xianning, S. (2020). Research and simulation of the machining process of difficult-to-cut materials. Ukrainian Journal of Mechanical Engineering and Materials Science, 6(3-4), 41-50. https://doi.org/10.23939/ujmems2020.03-04.041

Vancouver

Stupnytskyy V, Xianning S. Research and simulation of the machining process of difficult-to-cut materials. Ukrainian Journal of Mechanical Engineering and Materials Science. 2020;6(3-4):41-50. doi:10.23939/ujmems2020.03-04.041

BibTeX
@article{Stupnytskyy2020,
  author = {Stupnytskyy, Vadym and Xianning, She},
  title = {Research and simulation of the machining process of difficult-to-cut materials},
  journal = {Ukrainian Journal of Mechanical Engineering and Materials Science},
  year = {2020},
  volume = {6},
  number = {3-4},
  pages = {41--50},
  doi = {10.23939/ujmems2020.03-04.041}
}
Kostenlos starten →