COMPUTER SIMULATION OF CMOS AND SOI CMOS TRANSMISSION-GATE D-LATCHES FOR OPERATION OVER AN EXTREME TEMPERATURE RANGE
Infocommunication technologies and electronic engineering · 2026-11 · 6 (2) · 165-173
DOI: 10.23939/ictee2026.02.165 ↗Kurz gefasst
Fachartikel in der Zeitschrift Infocommunication technologies and electronic engineering, 2026-10. Verfasst von Ihor Kohut und 1 weiteren Autor:innen. Die Arbeit nennt 10 Literaturangaben.
Abstract (Originalsprache)
The paper presents a computer simulation study and a comparative thermal-stability analysis of circuit and layout solutions for D-latch elements intended for microsystem applications as signal-level latches for capacitive, resistive and photosensitive sensors, as well as building blocks of digital signal processing. Two circuit implementations were investigated: a baseline seven-transistor D-latch built around a single pass transistor and a weakened keeper inverter, and an enhanced ten-transistor D-latch employing complementary transmission gates for both data writing and feedback disconnection. Circuit analysis and dynamic-parameter estimation were carried out in LTspice, whereas layout design, design-rule verification and temperature simulation were performed with MicroWind using scalable lambda design rules for a 120 nm process, with both bulk CMOS and silicon-on-insulator (SOI) CMOS technological bases. All variants were simulated under a common set of electrical conditions: a 500 MHz clock, a 400 MHz data signal, 0.05 ns input transition times and full-swing inputs (1.2 V for bulk CMOS and 0.9 V for SOI CMOS), across a temperature range from −50 to +200 °C in 25 °C steps. The influence of the technological factor (migration from bulk CMOS to dielectrically isolated SOI CMOS) and of the circuit modification (introduction of transmission gates) on cell operability under extreme conditions was investigated separately and jointly. The baseline single-pass-transistor latch was found to remain operational from 0 to +200 °C in bulk CMOS and from +25 to +200 °C in SOI CMOS, i.e. the technological migration alone does not remove the low-temperature limit and even narrows it. A synergistic effect was revealed for the combination of SOI structures with a transmission-gate architecture, which compensates the temperature drift of threshold voltages and provides high signal-transfer symmetry: both transmission-gate variants retained correct state latching over the entire studied range of at least 250 °C. The SOI CMOS transmission-gate latch showed the highest thermal stability, retaining functional reliability and reliable state latching over an extended −50...+200 °C range at a power consumption of 1.570...1.932 µW and a temperature drift of only 23.1 %, at the cost of an increase in transistor count from seven to ten and in layout area from 21.38 to 27.07 µm² (+26.6 %). Averaged over the common +25...+200 °C operating range, the circuit modification alone reduces power consumption 4.73-fold in bulk CMOS and 5.50-fold in SOI CMOS, while the combined effect of both approaches reaches 18.8-fold at +25 °C and 20.3-fold at +200 °C. The results provide a quantitative basis for designing reliable and versatile micro- and nanosystem components intended for extreme operating conditions such as downhole instrumentation, automotive electronics and aerospace systems.
Zitieren
APA
Kohut, I., & Prystaiko, A. (2026). COMPUTER SIMULATION OF CMOS AND SOI CMOS TRANSMISSION-GATE D-LATCHES FOR OPERATION OVER AN EXTREME TEMPERATURE RANGE. Infocommunication technologies and electronic engineering, 6(2), 165-173. https://doi.org/10.23939/ictee2026.02.165
Vancouver
Kohut I, Prystaiko A. COMPUTER SIMULATION OF CMOS AND SOI CMOS TRANSMISSION-GATE D-LATCHES FOR OPERATION OVER AN EXTREME TEMPERATURE RANGE. Infocommunication technologies and electronic engineering. 2026;6(2):165-173. doi:10.23939/ictee2026.02.165
BibTeX
@article{Kohut2026,
author = {Kohut, Ihor and Prystaiko, Andrii},
title = {COMPUTER SIMULATION OF CMOS AND SOI CMOS TRANSMISSION-GATE D-LATCHES FOR OPERATION OVER AN EXTREME TEMPERATURE RANGE},
journal = {Infocommunication technologies and electronic engineering},
year = {2026},
volume = {6},
number = {2},
pages = {165--173},
doi = {10.23939/ictee2026.02.165}
}
EUVIMED