Research on the influence of internal structure parameters on the mechanical properties of products produced by the FDM method
Chemistry, technology and application of substances · 01.12.2026 · 9 (2) · 238-246
DOI: 10.23939/ctas2026.02.238 ↗Kurz gefasst
Fachartikel in der Zeitschrift Chemistry, technology and application of substances, online erschienen am 10.11.2026. Verfasst von D.I. Kechur und 2 weiteren Autor:innen. Die Arbeit nennt 23 Literaturangaben.
Abstract (Originalsprache)
The effects of print orientation and internal structural parameters on the mechanical properties of PETG specimens fabricated by FDM 3D printing were investigated. Under tensile loading, the on-edge orientation provided approximately 25% higher strength than the flat orientation at the same material consumption, owing to the alignment of the extruded filaments relative to the loading axis. The use of support structures had little effect on strength while increasing specimen ductility. Schwarz D, Fischer– Koch S, and honeycomb infill structures were compared at infill densities of 10, 15, and 20%. Among the specimens, Schwarz D exhibited the highest specific force, reaching 130 N/g at 10% infill, which corresponded to approximately 84% of the value obtained for the fully solid specimen. Fischer–Koch S showed the most stable deformation response, whereas the honeycomb structure exhibited the lowest resistance to compression.
Zitieren
APA
Kechur, D., Davydovych, A., & Grytsenko, O. M. (2026). Research on the influence of internal structure parameters on the mechanical properties of products produced by the FDM method. Chemistry, technology and application of substances, 9(2), 238-246. https://doi.org/10.23939/ctas2026.02.238
Vancouver
Kechur D, Davydovych A, Grytsenko OM. Research on the influence of internal structure parameters on the mechanical properties of products produced by the FDM method. Chemistry, technology and application of substances. 2026;9(2):238-246. doi:10.23939/ctas2026.02.238
BibTeX
@article{Kechur2026,
author = {Kechur, D.I. and Davydovych, A.V. and Grytsenko, O. M.},
title = {Research on the influence of internal structure parameters on the mechanical properties of products produced by the FDM method},
journal = {Chemistry, technology and application of substances},
year = {2026},
volume = {9},
number = {2},
pages = {238--246},
doi = {10.23939/ctas2026.02.238}
}
EUVIMED