EUVIMEDEUVIMED entdecken
Crossref

Influence of Application Modes on Increasing Bond Strength Longevity of Self-etching and Universal Adhesive Systems to Enamel

D L Falcione, C E Pena, C P Turssi, Fmg França, Flb do Amaral, J Tagami, R T Basting

Operative Dentistry · 2024

DOI: 10.2341/22-133-l ↗

Kurz gefasst

Fachartikel in der Zeitschrift Operative Dentistry, 2024. Verfasst von D L Falcione und 6 weiteren Autor:innen. Beteiligte Einrichtung: Daniel Locheider Falcione, PhD student, Faculdade São Leopoldo Mandic, São Paulo, Brazil. Hauptthemen laut MEDLINE: Dental Cements, Dental Bonding. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 63 Literaturangaben.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The present study aimed to evaluate the influence of application mode on the short-term microshear bond strength longevity of self-etching and universal adhesive systems to enamel, the failure mode, and the resulting enamel surface micromorphology. Ninety enamel surfaces were obtained from sound third molars, planed, and randomly assigned to nine groups, according to the application mode and the adhesive system (n=10). There were three primer application modes: according to the manufacturer's recommended application time (control), using double the application time recommended for the primer and selective enamel etching. The adhesive systems used were: Clearfil SE Bond (Kuraray), FL-Bond II (SHOFU), and Futurabond U (Voco). At least two resin-bonded composite cylinders (Grandioso Light Flow, Voco) were placed on each enamel surface, and then evaluated for microshear bond strength at 24 hours and 180 days of storage in solution body fluid (SBF) at pH 7.4. Failure modes were evaluated with a stereoscopic microscope at 20× magnification. A micromorphological analysis of the enamel surface was performed under a scanning electron microscope at 5000× magnification before and after the treatments. Mixed models for repeated measures over time showed significant interaction among application modes, adhesive systems, and time periods ( p =0.0331). The bond strength of FL-Bond II adhesive to enamel observed after performing selective enamel etching was significantly higher than that observed after applying the control treatment ( p =0.0010) at both 24 hours and 180 days. However, no significant difference was observed between the application of this same adhesive at double the time recommended by the manufacturer and the other two application modes ( p >0.05). There was also no significant difference in the microshear bond strength for the enamel treatments applied using Clearfil SE Bond and Futurabond U ( p >0.05). A significant reduction in bond strength to enamel was observed at the 180-day storage time for all the adhesive systems when selective enamel etching was performed ( p

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Dental CementsDental BondingAcid Etching, DentalComposite ResinsResin CementsDental EnamelMaterials TestingShear StrengthDentin-Bonding Agents

Substanzen

Dental CementsComposite ResinsResin CementsDentin-Bonding Agents

Autor:innen und Institutionen

  • Daniel Locheider Falcione, PhD student, Faculdade São Leopoldo Mandic, São Paulo, Brazil.
  • Carlos Eduardo Pena, professor, Centro de Extensão e Especialização Profissional Odontológica, São Paulo, Brazil.
  • Cecilia Pedroso Turssi, professor, Faculdade São Leopoldo Mandic, São Paulo, Brazil.
  • Fabiana Mantovani Gomes França, professor, Faculdade São Leopoldo Mandic, São Paulo, Brazil.
  • Flávia Lucisano Botelho do Amaral, professor, Faculdade São Leopoldo Mandic, São Paulo, Brazil.
  • Junji Tagami, visiting professor, Faculty of Dentistry, Chulalongkorn University, Bangkok, Thailand.

Zitieren

APA

Falcione, D. L., Pena, C. E., Turssi, C. P., França, F., Amaral, F. D., Tagami, J., & Basting, R. T. (2024). Influence of Application Modes on Increasing Bond Strength Longevity of Self-etching and Universal Adhesive Systems to Enamel. Operative Dentistry. https://doi.org/10.2341/22-133-l

Vancouver

Falcione DL, Pena CE, Turssi CP, França F, Amaral FD, Tagami J, et al. Influence of Application Modes on Increasing Bond Strength Longevity of Self-etching and Universal Adhesive Systems to Enamel. Operative Dentistry. 2024. doi:10.2341/22-133-l

BibTeX
@article{Falcione2024,
  author = {Falcione, D L and Pena, C E and Turssi, C P and França, Fmg and Amaral, Flb do and Tagami, J and Basting, R T},
  title = {Influence of Application Modes on Increasing Bond Strength Longevity of Self-etching and Universal Adhesive Systems to Enamel},
  journal = {Operative Dentistry},
  year = {2024},
  doi = {10.2341/22-133-l}
}
Kostenlos starten →