EUVIMEDEUVIMED entdecken
Crossref

Influence of the Scalpel Finishing Technique on Marginal Gap Formation in Class II Resin Composite Restorations

S Soliman, G Krastl, A Winkler, R Frankenberger, B Hahn

Operative Dentistry · 2023

DOI: 10.2341/22-027-l ↗

Kurz gefasst

Fachartikel in der Zeitschrift Operative Dentistry, 2023. Verfasst von S Soliman und 4 weiteren Autor:innen. Beteiligte Einrichtung: *Sebastian Soliman, DMD, University Hospital Würzburg, Department of Conservative Dentistry and Periodontology, Center of Dental Traumatology, Dental…. Hauptthemen laut MEDLINE: Dental Restoration, Permanent, Dental Marginal Adaptation. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 50 Literaturangaben.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Objectives

Modern adhesives and composites allow the restoration of deep defects. In such cases, the matrix technique is particularly challenging, and excess composite is a common problem. Removing such overhangs with a scalpel has already been described as a substance preserving or selective finishing technique. Clinically, restoration margins may appear as a white line after scalpel finishing, and it is unclear whether this line represents a marginal gap and/or whether scalpel finishing promotes marginal gap formation. Therefore, the aim of this study was to investigate the influence of scalpel finishing of deep Class II composite restorations on marginal gap formation. Methods and Materials Standardized mesioocclusal-distal (MOD) cavities were prepared and restored in 60 human molars randomly divided into six finishing protocol groups: G1, scalpels (SC); G2, oscillating files (OF); G3, finishing strips (FS); G4, scalpels and finishing strips (SC+FS); G5, scalpels and polishing discs (SC+PD); G6, polishing discs alone (PD, controls). The groups were additionally assigned to finishing and polishing in a phantom head (groups 1–4) or hand-held setting (groups 5–6) to simulate clinical and in-vitro research conditions, respectively. After restoration, artificial aging was performed by thermocycling (5–55°C, 2500 cycles) and mechanical loading (50 newtons (N) with 500,000 cycles) prior to scanning electron microscopy analysis of proximal restoration margin quality on the mesial and distal surfaces (n=120) of each tooth. Outcomes (perfect margin, marginal gap, overhang, marginal fracture) were statistically analyzed by t-test, Mann-Whitney U test, single-factor analysis of variance, post-hoc t-test, Kruskal-Wallis test and Dunn-Bonferroni correction for multiple group comparisons. Cohen’s effect size d( Cohen ) was calculated to show the strength of the relationship between variables.

Results

Overall, marginal quality was significantly better in the hand-held setting (SC+PD and PD) than the phantom head setting (SC, OF, FS, SC+FS). The best marginal quality was achieved with oscillating files in the phantom head setting and with scalpels plus polishing discs in the hand-held setting. Marginal gaps occurred significantly more often with scalpels, but the proportion of gaps was very low and clinically insignificant. Finishing strips were the least effective instruments for removing overhangs but performed better in combination with scalpels.

Conclusions

Scalpel finishing can effectively and gently remove overhangs from enamel. However, blades should be used with caution as they can cut the dentin and cementum. Scalpel finishing does not lead to a clinically relevant increase in marginal gaps, but should be followed by polishing, whenever possible, to eliminate any marginal fractures that might be present.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Dental Restoration, PermanentDental Marginal AdaptationHumansComposite ResinsDental EnamelMolarResin CementsDental Cavity PreparationMaterials Testing

Substanzen

Composite ResinsResin Cements

Autor:innen und Institutionen

  • *Sebastian Soliman, DMD, University Hospital Würzburg, Department of Conservative Dentistry and Periodontology, Center of Dental Traumatology, Dental School, Würzburg, Germany.
  • Gabriel Krastl, DMD, professor, University Hospital Würzburg, Department of Conservative Dentistry and Periodontology, Center of Dental Traumatology, Dental School, Würzburg, Germany.
  • Alexander Winkler, DMD, University Hospital Würzburg, Department of Conservative Dentistry and Periodontology, Center of Dental Traumatology, Dental School, Würzburg, Germany.
  • Roland Frankenberger, DMD, professor, Department of Conservative Dentistry, Dental School, University Hospital Marburg, Marburg, Germany.
  • Britta Hahn, DMD, University Hospital Würzburg, Department of Conservative Dentistry and Periodontology, Center of Dental Traumatology, Dental School, Würzburg, Germany.

Zitieren

APA

Soliman, S., Krastl, G., Winkler, A., Frankenberger, R., & Hahn, B. (2023). Influence of the Scalpel Finishing Technique on Marginal Gap Formation in Class II Resin Composite Restorations. Operative Dentistry. https://doi.org/10.2341/22-027-l

Vancouver

Soliman S, Krastl G, Winkler A, Frankenberger R, Hahn B. Influence of the Scalpel Finishing Technique on Marginal Gap Formation in Class II Resin Composite Restorations. Operative Dentistry. 2023. doi:10.2341/22-027-l

BibTeX
@article{Soliman2023,
  author = {Soliman, S and Krastl, G and Winkler, A and Frankenberger, R and Hahn, B},
  title = {Influence of the Scalpel Finishing Technique on Marginal Gap Formation in Class II Resin Composite Restorations},
  journal = {Operative Dentistry},
  year = {2023},
  doi = {10.2341/22-027-l}
}
Kostenlos starten →