EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Influence of raster angle on tensile properties of FDM additively manufactured plates made from carbon reinforced PET-G material

Abdelnaser Elayeb, Milan Jankovic, Stefan Dikic, Dragoljub Bekric, Igor Balac

Science of Sintering · 2023 · 55 (2) · 259-268

DOI: 10.2298/sos220916010e ↗

Kurz gefasst

Fachartikel in der Zeitschrift Science of Sintering, 2023. Verfasst von Abdelnaser Elayeb und 4 weiteren Autor:innen. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 28 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministry of Education, Science and Technological Development of the Republic of Serbia.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Tensile properties of thin plate specimens made from short carbon fiber reinforced PET-G material are experimentally evaluated for various raster angles (printing directions). In additive manufacturing (AM), raster angle is recognized as one of the key printing parameters which strongly influences the strength and stiffness of the final part. The relatively high average value of ultimate tensile strength was obtained for specimens printed with the 0? raster angle, compared to the value obtained for specimens printed with the 90? raster angle - 52.2 MPa and 25.4 MPa, respectively. Similarly, noticeably higher average value of modulus of elasticity was obtained for specimens printed with the 0? raster angle, compared to the value obtained for specimens printed with the 90? raster angle - 4752 MPa and 1569 MPa, respectively. Scanning electron microscopy (SEM) was used for analysis of specimens? fracture surfaces. SEM images revealed considerable volume fraction of voids (porosity). ?he porosity, together with weak bonding between two adjacent rasters, could be one of key factors for poor tensile properties of samples printed with rasters perpendicular to direction of load application (90? raster angle).

Förderung

  • Ministry of Education, Science and Technological Development of the Republic of Serbia

Zitieren

APA

Elayeb, A., Jankovic, M., Dikic, S., Bekric, D., & Balac, I. (2023). Influence of raster angle on tensile properties of FDM additively manufactured plates made from carbon reinforced PET-G material. Science of Sintering, 55(2), 259-268. https://doi.org/10.2298/sos220916010e

Vancouver

Elayeb A, Jankovic M, Dikic S, Bekric D, Balac I. Influence of raster angle on tensile properties of FDM additively manufactured plates made from carbon reinforced PET-G material. Science of Sintering. 2023;55(2):259-268. doi:10.2298/sos220916010e

BibTeX
@article{Elayeb2023,
  author = {Elayeb, Abdelnaser and Jankovic, Milan and Dikic, Stefan and Bekric, Dragoljub and Balac, Igor},
  title = {Influence of raster angle on tensile properties of FDM additively manufactured plates made from carbon reinforced PET-G material},
  journal = {Science of Sintering},
  year = {2023},
  volume = {55},
  number = {2},
  pages = {259--268},
  doi = {10.2298/sos220916010e}
}
Kostenlos starten →