Influence of holding time during rapid tempering after rapid austenitization on the microstructure and mechanical properties of low carbon steel
Journal of Mining and Metallurgy, Section B: Metallurgy · 2026 · 62 (1) · 13-24
DOI: 10.2298/jmmb250918002p ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Mining and Metallurgy, Section B: Metallurgy, 2026. Verfasst von Putu Reidita Putri und 7 weiteren Autor:innen. Die Arbeit nennt 27 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-SA 4.0).
Abstract (Originalsprache)
The rising demand for high-quality steel in construction, automotive, and other industrial sectors presents significant challenges, particularly regarding energy consumption and CO₂ emissions from large-scale production. This study explores the use of rapid tempering as a heat treatment strategy to enhance the mechanical properties of low carbon steel while potentially reducing the environmental footprint of steel manufacturing. Rapid tempering was performed following rapid austenitization at 1000°C for 90 seconds using a 7-kW induction furnace, followed by quenching in ice water. Soaking times of 5, 15, and 20 seconds were applied during tempering, and results were compared with conventional heat treatment. The rapid tempering process resulted in a microstructure consisting of tempered martensite, with only slight morphological changes in the martensitic phase compared to conventional tempering, and the formation of markedly finer cementite precipitates. Mechanical testing demonstrated superior performance in rapid tempering, with the 5-second condition achieving the highest hardness (422.667 HV), tensile strength (1308.9 MPa), and yield strength (1270 MPa), while the 20- second condition yielded the highest toughness (139.336 J/cm²) and elongation (33.833%). Based on the balance among tensile strength, hardness, and toughness, the RA-RT 5- second specimen exhibited the most optimal mechanical performance.
Zitieren
APA
Putri, P. R., Korda, A., Basuki, E., Muhammad, F., Laksana, T., Priambudi, D., Syaukhani, I. A., & Santosa, B. (2026). Influence of holding time during rapid tempering after rapid austenitization on the microstructure and mechanical properties of low carbon steel. Journal of Mining and Metallurgy, Section B: Metallurgy, 62(1), 13-24. https://doi.org/10.2298/jmmb250918002p
Vancouver
Putri PR, Korda A, Basuki E, Muhammad F, Laksana T, Priambudi D, et al. Influence of holding time during rapid tempering after rapid austenitization on the microstructure and mechanical properties of low carbon steel. Journal of Mining and Metallurgy, Section B: Metallurgy. 2026;62(1):13-24. doi:10.2298/jmmb250918002p
BibTeX
@article{Putri2026,
author = {Putri, Putu Reidita and Korda, Akhmad and Basuki, Eddy and Muhammad, Fadhli and Laksana, Tria and Priambudi, Djalu and Syaukhani, Imam Al and Santosa, Berti},
title = {Influence of holding time during rapid tempering after rapid austenitization on the microstructure and mechanical properties of low carbon steel},
journal = {Journal of Mining and Metallurgy, Section B: Metallurgy},
year = {2026},
volume = {62},
number = {1},
pages = {13--24},
doi = {10.2298/jmmb250918002p}
}
EUVIMED