EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Component-Method Analysis of Composite Beam-to-Column Joints with a Non-Extended End Plate

Mehdi SEGHIRI, Rachid SLIMANI, Abderrahmane MENASRIA, Kadidja SEKHRI

International Journal of Computational and Experimental Science and Engineering · 04.05.2026 · 12 (2)

DOI: 10.22399/ijcesen.5117 ↗

Kurz gefasst

Fachartikel in der Zeitschrift International Journal of Computational and Experimental Science and Engineering, online erschienen am 04.05.2026. Verfasst von Mehdi SEGHIRI und 3 weiteren Autor:innen. Die Arbeit nennt 40 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Composite beam–to-column joints significantly influence the global stiffness, strength, and force redistribution capacity of steel–concrete composite frames. Although the Eurocode component method provides a rational basis for characterization joint, its manual application remains time-consuming and error-prone, which limits its systematic use in design and parametric assessment. This study applies the Eurocode 3/Eurocode 4 component method to composite beam–column joints with a non-extended end plate, and develops a dedicated calculation program to evaluate the joint design moment resistance ( ) and initial rotational stiffness ( ) and to support parametric studies. The parametric results show that increasing the slab longitudinal reinforcement ratio can raise ( ) by up to 27.53% (limited end-plate configuration) and increase ( ) by up to 122.416% (non-extended end plate configuration). Increasing the beam section height enhances ( ) by up to 83.068%, while the stiffness advantage of the flush end plate over the limited end plate can reach 110.944%. The end-plate thickness exhibits a saturation effect: beyond a threshold thickness close to flange thickness of profile tfc, further increases provide negligible gains in ( ) and ( ). These findings provide practical guidance for optimizing joint detailing and avoiding unnecessary over-dimensioning, while the developed software enables rapid Eurocode-consistent evaluation of composite joint performance.

Zitieren

APA

SEGHIRI, M., SLIMANI, R., MENASRIA, A., & SEKHRI, K. (2026). Component-Method Analysis of Composite Beam-to-Column Joints with a Non-Extended End Plate. International Journal of Computational and Experimental Science and Engineering, 12(2). https://doi.org/10.22399/ijcesen.5117

Vancouver

SEGHIRI M, SLIMANI R, MENASRIA A, SEKHRI K. Component-Method Analysis of Composite Beam-to-Column Joints with a Non-Extended End Plate. International Journal of Computational and Experimental Science and Engineering. 2026;12(2). doi:10.22399/ijcesen.5117

BibTeX
@article{SEGHIRI2026,
  author = {SEGHIRI, Mehdi and SLIMANI, Rachid and MENASRIA, Abderrahmane and SEKHRI, Kadidja},
  title = {Component-Method Analysis of Composite Beam-to-Column Joints with a Non-Extended End Plate},
  journal = {International Journal of Computational and Experimental Science and Engineering},
  year = {2026},
  volume = {12},
  number = {2},
  doi = {10.22399/ijcesen.5117}
}
Kostenlos starten →