EUVIMEDEUVIMED entdecken
Crossref

A Web-Based Program to Facilitate Prescription of Twice-Weekly Hemodialysis

Arin P Vansomphone, Tammy L Sirich iD, Timothy W Meyer iD

Clinical Journal of the American Society of Nephrology · 29.04.2026

DOI: 10.2215/cjn.0000001103 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Clinical Journal of the American Society of Nephrology, online erschienen am 29.04.2026. Verfasst von Arin P Vansomphone und 2 weiteren Autor:innen. Beteiligte Einrichtung: Departments of Medicine, Stanford University and VA Palo Alto HCS, Palo Alto California. Die Arbeit nennt 10 Literaturangaben. Gefördert von: NIDDK NIH HHS, Sapp Family CS Stanford Bio-X, National Institute of Diabetes and Digestive and Kidney Diseases.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Increasing consideration is being given to reducing hemodialysis frequency and/or treatment time for patients with residual kidney function.1 Several methods have been proposed for prescribing dialysis in such patients.2–4 The prescription parameter most commonly evaluated in the United States is the weekly standard Kt/Vurea (stdKt/V). Gotch2 developed this parameter on the basis of the premise that when a patient has residual function, the intensity of dialysis can be reduced until the average pretreatment plasma urea nitrogen (PUN) level is the same as it would be if the patient were receiving adequate dialysis in the absence of residual function. However, the 2015 Update of the Kidney Disease Outcomes Quality Initiative (KDOQI) Clinical Practice Guideline for Hemodialysis Adequacy (2015 KDOQI Update) increased the weight assigned to residual function in the calculation of stdKt/V.3 This change, which was largely unheralded, reduced the time that would be predicted to achieve a specified stdKt/V in patients with residual function. The 2015 KDOQI Update did not provide a simple means to estimate the time predicted to achieve a target stdkt/V with twice-weekly. We previously developed a mobile phone application to estimate these treatment times.5 The current report describes an improved web-based program which predicts treatment times predicted to achieve a target stdKt/V and also displays predicted PUN profiles. While PUN is not an adequacy marker under the 2015 KDOQI Update, values are routinely presented in patients' monthly reports. Physicians who reduce treatment time in accord with the Update can expect their patients' pre-treatment PUN values to increase. The current program allows physicians to anticipate the magnitude of this increase which is otherwise not easily calculable. The program is available at https://medcalculators.stanford.edu/dialysis, and its interface is shown in Figure 1. The user enters anthropometric data from which the program estimates the urea distribution volume as 0.9 times the body water volume calculated using the Watson formula.6 The user then enters values for the current treatment time on thrice-weekly hemodialysis, the total weekly ultrafiltration volume, the residual urea clearance (Kru), the single pool Kt/V (spKt/V) on thrice-weekly hemodialysis, and the target stdKt/V. The default target stdKt/V is 2.3 as specified by the 2015 KDOQI Update3; a different value may be entered if preferred. The user also enters the pretreatment PUN used in calculating spKt/V and notes whether this PUN was obtained before the first, second, or third weekly treatment. The program https://medcalculators.stanford.edu/dialysis-vd-urea makes the same calculations, but allows the user to enter a urea distribution volume different from that calculated by the Watson formula.Figure 1: Program’s interface. The figure shows the results obtained for a female patient, 165 cm tall and aged 60 years, who weighed 60 kg at the end of treatment. Current thrice-weekly dialysis for 210 minutes with removal of 5 L over the week provides a spKt/V of 1.3 while the measured Kru is 2.5 ml/min. The program first depicts () the estimated PUN profile for the current thrice weekly treatment which yielded the measured midweek pretreatment PUN of 60 mg/dl. The program then indicates that the specified target stdKt/V of 2.3 could be obtained with a reduction of thrice-weekly treatment time to 106 minutes and depicts () the estimated PUN profile for this treatment, noting that this would be expected to increase the UFR after the longest intradialytic interval well above a commonly proposed maximal rate of 13 ml/kg per hour. Finally, the program indicates that the specified target stdKt/V of 2.3 could also be obtained with twice-weekly treatment for 186 minutes and depicts () the estimated PUN profile for this treatment, noting that this would also be expected to increase the ultrafiltration rate after the longest intradialytic interval above a commonly proposed maximal rate of 13 ml/kg per hour. The program and a fuller description of its operation are available at https://medcalculators.stanford.edu/dialysis. Kru, residual urea clearance; PUN, plasma urea nitrogen; spKt/V, single pool Kt/V; stdKt/V, standard Kt/Vurea; UFR, ultrafiltration rate.On the basis of these inputs, the program first estimates the dialytic urea clearance from the spKt/V, treatment time, and urea distribution volume. An iterative program then generates a PUN profile through a week of dialysis on the basis of this dialytic urea clearance along with the urea distribution volume, treatment time, weekly ultrafiltration volume, and an arbitrarily assumed urea generation rate. The program then adjusts the urea generation rate to make the modeled pretreatment PUN match the measured value on the day of adequacy testing. It then displays the predicted PUN profile through the weekly dialysis cycle. After generating the PUN profile predicted for the current thrice weekly treatment, the program uses our previously described iterative method to estimate treatment times predicted to achieve the target stdKt/V for both twice-weekly and thrice-weekly treatment.5 It then uses the values calculated for the dialytic urea clearance and generation rate to predict weekly PUN profiles for both twice-weekly and thrice-weekly treatments which would provide the target stdKt/V. It further notes whether the ultrafiltration rates (UFR) with these times would exceed 13 ml/kg per hour and calculates the treatment times required to reduce the UFR below that value. By selecting appropriate tabs, the user can compare the predicted PUN profiles with twice-weekly and thrice-weekly dialysis and compare these profiles with the PUN profile for the current thrice weekly treatment. The user can also plot the average peak and time-averaged PUN and obtain numeric values for these parameters and PUN values at any time during the week by moving the cursor along the displayed PUN profiles. We should note limitations of our program. It derives the dialytic urea clearance from spKt/V using an estimated two compartment urea distribution volume instead of a theoretical single compartment urea distribution volume. This introduces only a small error for patients receiving adequate thrice-weekly dialysis.7 Our program also ignores the effects on urea clearance of differing UFR. PUN profiles and other dialysis parameters generated without these simplifying assumptions are provided by the web-based Solute-Solver program which also predicts results for a wider range of treatment schedules and for nonurea solutes.8,9 A wider range of dialysis parameters can also be calculated using the European Renal Calculator app developed by Casino et al.4 which uses the original variable target method for incorporating residual function. It should be noted that Kru can be calculated using different methods, and this may affect the treatment time predicted to achieve a target stdKt/V. The document “How the Web-Based stdKt/V-calculator Program Works” presented under “Additional Resources” at https://medcalculators.stanford.edu/dialysis further describes these methods and compares results obtained with our program with those obtained using Solute Solver. Our program also incorporates standard assumptions about urea distribution. It assumes that urea is distributed between two compartments having a 2:1 volume ratio. It further assumes that urea diffuses between these compartments at a rate which is proportional to the total urea distribution volume and that fluid is added to and removed only from the smaller compartment. Modeled PUN values on the basis of these assumptions have come close to PUN values observed in various circumstances, but the assumptions may not accurately describe urea’s distribution in the body. We should emphasize limitations of our program and of other dialysis models that we believe are more important than the details of urea kinetic calculations noted above. The program assumes that urea generation rates, Kru, dialytic urea clearances, and weekly ultrafiltration volumes remain constant over time. The program https://medcalculators.stanford.edu/dialysis-prescription hosted at the same site allows users to estimate stdKt/V from spKt/V values provided in successive monthly dialysis reports. Most importantly, the program presumes that the goal of treatment is to achieve a target stdKt/V. The 2015 KDOQI Update3 emphasized that achieving a target stdKt/V does not guarantee optimal treatment. Achieving a stdKt/V of 2.3 was considered equivalent to achieving a spKt/V of 1.4 at each of three-weekly treatments. However, the suggestion to target a stdKt/V of 2.3 was rated not graded. Thus, while it estimates the treatment time predicted to achieve a target stdKt/V, our program provides no escape from the weakness of using a single, urea-based parameter to characterize dialysis adequacy in all patients. Three other issues require comment. First, our program generates treatment times of less than 3 hour for patients with high Kru. The 2015 KDOQI Update3 recommended treatment for at least 3 hour. However, this recommendation was rated 1D, a strong recommendation supported by very low quality evidence. Second, while stdKt/V values are provided in patients' records at some dialysis centers, they are not uniformly calculated according to the 2015 Update. Third, while the level of 13 ml/hr per kg has been proposed as a warning of excessive ultrafiltration, lower rates may pose risk particularly in obese patients.10 In conclusion, there is increasing interest in reducing treatment frequency and/or time for patients with residual kidney function. The 2015 KDOQI Hemodialysis Adequacy Guideline Update3 reduced the time required to achieve a target stdKt/V for such patients. Our program provides a simple means to estimate the treatment times predicted to achieve a target stdKt/V when changing from thrice weekly to twice weekly dialysis and predicts PUN and spKt/V values which may be observed if this is done.

Schlagwörter

Stichwörter der Autor:innen

dialysishemodialysis adequacyurea modeling

Autor:innen und Institutionen

  • Departments of Medicine, Stanford University and VA Palo Alto HCS, Palo Alto California.

ORCID-Profile: Tammy L Sirich, Timothy W Meyer

Förderung

  • NIDDK NIH HHS
  • Sapp Family CS Stanford Bio-X
  • National Institute of Diabetes and Digestive and Kidney Diseases

Zitieren

APA

Vansomphone, A. P., Sirich, T. L., & Meyer, T. W. (2026). A Web-Based Program to Facilitate Prescription of Twice-Weekly Hemodialysis. Clinical Journal of the American Society of Nephrology. https://doi.org/10.2215/cjn.0000001103

Vancouver

Vansomphone AP, Sirich TL, Meyer TW. A Web-Based Program to Facilitate Prescription of Twice-Weekly Hemodialysis. Clinical Journal of the American Society of Nephrology. 2026. doi:10.2215/cjn.0000001103

BibTeX
@article{Vansomphone2026,
  author = {Vansomphone, Arin P and Sirich, Tammy L and Meyer, Timothy W},
  title = {A Web-Based Program to Facilitate Prescription of Twice-Weekly Hemodialysis},
  journal = {Clinical Journal of the American Society of Nephrology},
  year = {2026},
  doi = {10.2215/cjn.0000001103}
}
Kostenlos starten →