Cr(VI) Adsorptive Removal Using Raw Cordia africana Sawdust: Optimization of Operating Parameters, Kinetics, Isotherm, Thermodynamics, and Desorption Efficiency
Advances in Environmental and Engineering Research · 24.04.2026 · 07 (02) · 1-26
DOI: 10.21926/aeer.2602007 ↗Kurz gefasst
Fachartikel in der Zeitschrift Advances in Environmental and Engineering Research, online erschienen am 24.04.2026. Verfasst von Aster Woldu Gebrearegay und 2 weiteren Autor:innen. Die Arbeit nennt 20 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Hexavalent chromium (Cr(VI)) is a carcinogenic pollutant commonly found in wastewater from tanning and electroplating industries. This study investigates the efficiency of raw Cordia africana sawdust as a biosorbent for Cr(VI) removal. Batch adsorption experiments were conducted by varying pH (3-8), contact time (10-120 min), and Cr(VI) concentration (21-47 mg/L) using Response Surface Methodology (RSM) with Box-Behnken design. Characterization was performed using FTIR, SEM, BET, pH, and PZC analysis before and after adsorption to confirm uptake mechanisms. Desorption studies were conducted using 0.1 M HCl and 0.1 M NaOH. FTIR confirmed the presence of hydroxyl (3330 cm-1) and carboxyl (1733 cm-1) groups, with peak shifts after adsorption, indicating their involvement. SEM revealed heterogeneous surface morphology, and the BET surface area was 10.332 m2/g with PZC at 6.8. Optimal Cr(VI) removal of 84.5% occurred at pH 5.5, 47 mg/L concentration, and 10 min contact time. HCl-mediated desorption achieved 66.5% Cr(VI) recovery of efficiency, while the regenerated adsorbent maintained 78.8% of its initial capacity across three cycles. Kinetic analysis showed that the pseudo-second-order model best described adsorption (R2 = 0.996) with qe,cal (1.99 mg/g) matching the experimental value, indicating chemisorption as the rate-controlling step. Isotherm studies using non-linear regression (OriginPro 2024) revealed the Langmuir model as the best fit (R2 = 0.993, RMSE = 0.042) with a maximum capacity of 2.06 mg/g, suggesting monolayer adsorption onto homogeneous sites. The dimensionless separation factor (RL = 0.10-0.21) confirmed favorable adsorption. The Dubinin-Radushkevich model gave a mean free energy of E = 8.42 kJ mol-1, indicating an ion-exchange contribution. Thermodynamic parameters (ΔG° = -4.21 to -6.42 kJ mol-1, ΔH° = +18.7 kJ mol-1, ΔS° = +0.077 kJ mol-1 K-1) revealed spontaneous and endothermic adsorption. Comparative analysis with ten reported biosorbents shows Cordia africana sawdust performs favorably among unmodified materials (2.06 mg/g vs 1.58-1.94 mg/g range). However, raw sawdust cannot replace conventional methods like alkaline precipitation (which achieves >99% removal) due to capacity limitations and concerns about spent adsorbent disposal. The material shows potential as a low-cost supplementary treatment in resource-limited settings where waste biomass is abundant.
Zitieren
APA
Gebrearegay, A. W., Tesfaye, M., & Gizaw, A. (2026). Cr(VI) Adsorptive Removal Using Raw Cordia africana Sawdust: Optimization of Operating Parameters, Kinetics, Isotherm, Thermodynamics, and Desorption Efficiency. Advances in Environmental and Engineering Research, 07(02), 1-26. https://doi.org/10.21926/aeer.2602007
Vancouver
Gebrearegay AW, Tesfaye M, Gizaw A. Cr(VI) Adsorptive Removal Using Raw Cordia africana Sawdust: Optimization of Operating Parameters, Kinetics, Isotherm, Thermodynamics, and Desorption Efficiency. Advances in Environmental and Engineering Research. 2026;07(02):1-26. doi:10.21926/aeer.2602007
BibTeX
@article{Gebrearegay2026,
author = {Gebrearegay, Aster Woldu and Tesfaye, Melaku and Gizaw, Alemu},
title = {Cr(VI) Adsorptive Removal Using Raw Cordia africana Sawdust: Optimization of Operating Parameters, Kinetics, Isotherm, Thermodynamics, and Desorption Efficiency},
journal = {Advances in Environmental and Engineering Research},
year = {2026},
volume = {07},
number = {02},
pages = {1--26},
doi = {10.21926/aeer.2602007}
}
EUVIMED