EUVIMEDEUVIMED entdecken
Crossref

Numerical Simulation of Electric Field Distribution in Electrochemical Machining of Titanium Alloys

Aleksandra A. Sokolova, Natalia M. Sherykhalina, Airat R. Urakov, Ekaterina R. Shaimardanova

Multiphase Systems · 30.09.2026 · 21 (3) · 123-128

DOI: 10.21662/mfs2026.3.019 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Multiphase Systems, online erschienen am 30.09.2026. Verfasst von Aleksandra A. Sokolova und 3 weiteren Autor:innen.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study examines the dimensionless electric field distribution in a two-dimensional model of the interelectrode region during electrochemical machining (ECM). The investigation was prompted by damage observed on the lateral surfaces of titanium workpieces outside the intended machining zone. The aim is to assess edge effects and compare electric field strengths within the working gap and in adjacent regions of the electrolyte. The model geometry is defined independently of physical dimensions, with the ratio of the interelectrode gap height to the vertical dimension of the electrode serving as a key parameter. The electrolyte is treated as an unbounded medium, and the potential difference between the electrodes is specified as a model parameter. Edge rounding radii are not explicitly prescribed. The analysis is based on finite element simulations performed in ELCUT. The results are presented as the dimensionless electric field magnitude E∗. The exported data are used to construct spatial profiles and a map of the dimensionless field strength distribution. Interpolated contour lines are presented for the lateral regions to illustrate spatial variations in the field. The E∗ values vary only slightly across the selected section of the gap. The field is weaker in the lateral regions, where elevated values are concentrated near the gap level and decrease with distance from it along the directions examined. These findings are consistent with the possibility of stray dissolution outside the intended machining zone. Establishing the causes of the damage, however, requires comparison of the calculated fielddistributions with the observed surface condition and the electrochemical characteristics of the alloy in the electrolyte used. The identified field patterns suggest possible modifications to the tool electrode geometry and the placement of insulating shields. The effectiveness of these modifications should be assessed through further simulations, including mesh convergence checks, and experimental investigation.

Zitieren

APA

Sokolova, A. A., Sherykhalina, N. M., Urakov, A. R., & Shaimardanova, E. R. (2026). Numerical Simulation of Electric Field Distribution in Electrochemical Machining of Titanium Alloys. Multiphase Systems, 21(3), 123-128. https://doi.org/10.21662/mfs2026.3.019

Vancouver

Sokolova AA, Sherykhalina NM, Urakov AR, Shaimardanova ER. Numerical Simulation of Electric Field Distribution in Electrochemical Machining of Titanium Alloys. Multiphase Systems. 2026;21(3):123-128. doi:10.21662/mfs2026.3.019

BibTeX
@article{Sokolova2026,
  author = {Sokolova, Aleksandra A. and Sherykhalina, Natalia M. and Urakov, Airat R. and Shaimardanova, Ekaterina R.},
  title = {Numerical Simulation of Electric Field Distribution in Electrochemical Machining of Titanium Alloys},
  journal = {Multiphase Systems},
  year = {2026},
  volume = {21},
  number = {3},
  pages = {123--128},
  doi = {10.21662/mfs2026.3.019}
}
Kostenlos starten →