EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

A comparison of struvite precipitation thermodynamics and kinetics modelling techniques

Leynard Natividad-Marin, Max William Burns, Phil Schneider

Water Science and Technology · 15.03.2023 · 87 (6) · 1393-1422

DOI: 10.2166/wst.2023.061 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Water Science and Technology, online erschienen am 02.03.2023. Verfasst von Leynard Natividad-Marin und 2 weiteren Autor:innen. Beteiligte Einrichtung: College of Science and Engineering, James Cook University, 1 James Cook Dr, Douglas, QLD 4811, Australia E-mail: eynard.natividadmarin@my.jcu.edu.au. Hauptthemen laut MEDLINE: Phosphates. Die Arbeit wurde bisher 22-mal zitiert (Crossref) und nennt 116 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Solution thermodynamics and kinetic modelling applied to struvite crystallisation–precipitation were reviewed from diverse references to determine proximity between predicted and cited experimental measurements. These simulations show the expected variability range of struvite saturation calculation when only limited solution compositional information is given, showing acceptable agreement between predicted and experimental struvite mass. This work also compares results from struvite crystallisation kinetic studies on liquid phase species depletion, crystallisation induction time, primary nucleation, secondary nucleation, crystal growth, and crystal aggregation. Large inconsistencies between reported kinetics were observed in many scenarios. Variations in species depletion models highlighted that they are only suitably applied to the specific system from which they were regressed. Spontaneous primary nucleation was predicted to occur in the range of SI = 0.237–0.8. Predicted primary nucleation rates vary over at least 10 orders of magnitude (depending on supersaturation) because of uncertainties in interfacial tension and maximum achievable nucleation rate. Secondary nucleation rates are more agreeable, varying over approximately two orders of magnitude. Growth rates varied over five orders of magnitude due to variations in experimental conditions. Aggregation rates are not thoroughly examined enough to make any inferences.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

PhosphatesStruviteKineticsThermodynamicsCrystallizationChemical Precipitation

Substanzen

StruvitePhosphates

Autor:innen und Institutionen

  • College of Science and Engineering, James Cook University, 1 James Cook Dr, Douglas, QLD 4811, Australia E-mail: eynard.natividadmarin@my.jcu.edu.au.

Zitieren

APA

Natividad-Marin, L., Burns, M. W., & Schneider, P. (2023). A comparison of struvite precipitation thermodynamics and kinetics modelling techniques. Water Science and Technology, 87(6), 1393-1422. https://doi.org/10.2166/wst.2023.061

Vancouver

Natividad-Marin L, Burns MW, Schneider P. A comparison of struvite precipitation thermodynamics and kinetics modelling techniques. Water Science and Technology. 2023;87(6):1393-1422. doi:10.2166/wst.2023.061

BibTeX
@article{NatividadMarin2023,
  author = {Natividad-Marin, Leynard and Burns, Max William and Schneider, Phil},
  title = {A comparison of struvite precipitation thermodynamics and kinetics modelling techniques},
  journal = {Water Science and Technology},
  year = {2023},
  volume = {87},
  number = {6},
  pages = {1393--1422},
  doi = {10.2166/wst.2023.061}
}
Kostenlos starten →