EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Experimental study on residual stresses in stud welding based on X-ray diffraction and the blind-hole method

Wei Li, Yangming Xu, Yuhao Liu, Heyuan Zhou, Sicong Wei, Xu Han

Vibroengineering Procedia · 22.04.2026 · 61 · 137-143

DOI: 10.21595/vp.2026.25950 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Vibroengineering Procedia, online erschienen am 22.04.2026. Verfasst von Wei Li und 5 weiteren Autor:innen. Die Arbeit nennt 12 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

During the stud welding process, residual stresses are inevitably induced due to the significant temperature gradients and associated heterogeneous thermal expansion and contraction. These residual stresses significantly influence the mechanical properties of the welded structure. Quantitative evaluation of the welding residual stress distribution on the steel plate surface was performed using X-ray diffraction (XRD) and the blind-hole method. Results demonstrate that the radial residual stress initially increases and subsequently decreases with increasing distance from the weld ring. The circumferential residual stress is characterized as compressive throughout the measured region, also exhibiting an initial increase, followed by a decrease, and a subsequent increase with greater distance from the weld center. Both radial and circumferential stresses form a compressive stress zone within the weld and its immediate vicinity, with a peak value of approximately 170 MPa. The significant solid-state phase transformations occurring in the weld metal and the adjacent heat-affected zone lead to the development of compressive stresses upon cooling. The compressive stresses observed in the base metal region, far from the weld, are likely attributable to the initial rolling stresses inherent to the steel plate.

Zitieren

APA

Li, W., Xu, Y., Liu, Y., Zhou, H., Wei, S., & Han, X. (2026). Experimental study on residual stresses in stud welding based on X-ray diffraction and the blind-hole method. Vibroengineering Procedia, 61, 137-143. https://doi.org/10.21595/vp.2026.25950

Vancouver

Li W, Xu Y, Liu Y, Zhou H, Wei S, Han X. Experimental study on residual stresses in stud welding based on X-ray diffraction and the blind-hole method. Vibroengineering Procedia. 2026;61:137-143. doi:10.21595/vp.2026.25950

BibTeX
@article{Li2026,
  author = {Li, Wei and Xu, Yangming and Liu, Yuhao and Zhou, Heyuan and Wei, Sicong and Han, Xu},
  title = {Experimental study on residual stresses in stud welding based on X-ray diffraction and the blind-hole method},
  journal = {Vibroengineering Procedia},
  year = {2026},
  volume = {61},
  pages = {137--143},
  doi = {10.21595/vp.2026.25950}
}
Kostenlos starten →