EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Research on calibration method of electronic control parameters based on engine model

Sheng Lu, Changshui Wu, Xianzheng Ling, Yangbo Liu

Mathematical Models in Engineering · 30.06.2016 · 2 (1) · 34-40

DOI: 10.21595/mme.2016.16867 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Mathematical Models in Engineering, online erschienen am 30.06.2016. Verfasst von Sheng Lu und 3 weiteren Autor:innen. Die Arbeit nennt 7 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The MBC (calibration model-based) toolbox in MATLAB software and Ricardo Wave were used to optimize the power performance of a gasoline engine. In the calibration process, Firstly, the wave simulation model of the engine was established and validated; then, engine operating points were determined by using the design of experiments (DOE) method, and parameters and performance (torque, fuel consumption, power and the cylinder maximum pressure, etc.) of the engine at these operating points were calculated by the simulation model. Finally, the engine mathematical statistical model was established and calibration optimization. The engine ignition advance angle, air-fuel ratio and the torque of the engine were obtained. The results show that the method combined with the modern DoE test design theory and automatic calibration technology not only makes the engine torque from 198 Nm to 215 Nm, but also greatly reduces the test time and improve the calibration efficiency

Zitieren

APA

Lu, S., Wu, C., Ling, X., & Liu, Y. (2016). Research on calibration method of electronic control parameters based on engine model. Mathematical Models in Engineering, 2(1), 34-40. https://doi.org/10.21595/mme.2016.16867

Vancouver

Lu S, Wu C, Ling X, Liu Y. Research on calibration method of electronic control parameters based on engine model. Mathematical Models in Engineering. 2016;2(1):34-40. doi:10.21595/mme.2016.16867

BibTeX
@article{Lu2016,
  author = {Lu, Sheng and Wu, Changshui and Ling, Xianzheng and Liu, Yangbo},
  title = {Research on calibration method of electronic control parameters based on engine model},
  journal = {Mathematical Models in Engineering},
  year = {2016},
  volume = {2},
  number = {1},
  pages = {34--40},
  doi = {10.21595/mme.2016.16867}
}
Kostenlos starten →