Comparison of results of three-dimensional modeling of magnetotelluric data using finite difference and integral equation methods
Геофизические исследования · 01.10.2026 · 27 (3) · 5
DOI: 10.21455/gr2026.3-1 ↗Kurz gefasst
Fachartikel in der Zeitschrift Геофизические исследования, online erschienen am 01.10.2026. Verfasst von Danila Popov und 1 weiteren Autor:innen. Die Arbeit nennt 11 Literaturangaben.
Abstract (Originalsprache)
A comparison of forward 3D magnetotelluric sounding (MTS) solutions obtained using two programs is performed. The first, MT3DFwd (author – R. Mackie), is based on the finite difference method and has been widely used since the 1990s. The second program, GEMMIE (author – M.S. Kruglyakov), is based on the integral equation method and has been actively developed in recent years, also allowing one to solve the inverse problem. The calculations were performed on the Lomonosov-2 supercomputer at Moscow State University. The comparison of the results was performed for a rather complex model containing 3D heterogeneities at three structural levels: in the sedimentary cover, in the consolidated crust, and in the upper mantle. The calculations using the GEMMIE program were performed for two different vertical grids, one with 79 cells, as in the MT3DFwd program, and one with 37 cells. Additionally, different degrees of Legendre polynomials applied in GEMMIE for approximating the field inside the cell were used. The results demonstrated that with an increase in the degrees of the polynomials, the calculation time increases, but the accuracy increases, which allows for the successful use of a coarser vertical grid. Comparison of the calculation results using the MT3DFwd and GEMMIE programs showed that the greatest differences are observed near the boundaries of near-surface structures - uplift and depression of the high-resistivity basement. For example, for the effective apparent resistivity, the differences manifest as a vertical shift of the curves over a wide period range, reaching up to 30% at some MT sites and up to 45% when zero-degree polynomials (piecewise-constant field in cells) are used. For the effective impedance phase, the differences do not exceed 2°, which approximately corresponds to the typical observation error. In the tipper norm, the differences strongly depend on the period and are maximal at periods of about 1 s, where at some sites they reach 0.09. However, at most MTS sites the results are close and visually indistinguishable. To determine which program provides more accurate results for this model, additional calculations using other programs are desirable.
Zitieren
APA
Popov, D., & Pushkarev, P. (2026). Comparison of results of three-dimensional modeling of magnetotelluric data using finite difference and integral equation methods. Геофизические исследования, 27(3), 5. https://doi.org/10.21455/gr2026.3-1
Vancouver
Popov D, Pushkarev P. Comparison of results of three-dimensional modeling of magnetotelluric data using finite difference and integral equation methods. Геофизические исследования. 2026;27(3):5. doi:10.21455/gr2026.3-1
BibTeX
@article{Popov2026,
author = {Popov, Danila and Pushkarev, Pavel},
title = {Comparison of results of three-dimensional modeling of magnetotelluric data using finite difference and integral equation methods},
journal = {Геофизические исследования},
year = {2026},
volume = {27},
number = {3},
pages = {5},
doi = {10.21455/gr2026.3-1}
}
EUVIMED