EUVIMEDEUVIMED entdecken
Crossref

Ultralow Concentration Guar Gum Fracturing Fluid System with Ultrahigh Proppant Concentration

Xuge Zhou, Zhongcong Zhao, Mingjia Hu, Tengfei Chen, Junjie Xiong, Lifeng Chen, Depei Xu, Xiaohui Sun, Wendong Jia, Yanxin Hou

SPE Journal · 12.08.2026 · 31 (08) · 5370-5389

DOI: 10.2118/233789-pa ↗

Kurz gefasst

Fachartikel in der Zeitschrift SPE Journal, online erschienen am 05.06.2026. Verfasst von Xuge Zhou und 9 weiteren Autor:innen. Die Arbeit nennt 27 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

High polymer loadings, significant residue-induced formation damage, and an inherent compromise between proppant transport and operational control limit the effectiveness of conventional guar gum fracturing fluids. With this study, we present a solution in the form of an ultralow-concentration hydroxypropyl guar (HPG) system enabled by a novel polymeric boron crosslinker. The crosslinker is synthesized from acrylamide, a boron-functional monomer (3-acrylamidophenylboronic acid), and a cationic monomer ([2-(acryloyloxy)ethyl]trimethylammonium chloride). Performance is advanced through three key innovations. First, a strategy of “physical modulation of crosslinking kinetics” is introduced. Gelation time (2–10 minutes) is controlled in real time by adjusting the inversion-agent dosage, effecting a paradigm shift from chemical design to physical process control. Second, the HPG concentration is dramatically reduced to 0.15 wt%, significantly reducing the potential for formation damage. Third, at this ultralow loading, the fluid achieves a high proppant-carrying capacity, sustaining proppant concentrations up to 50%. Laboratory testing at 90°C and 170 s⁻¹ for 90 minutes confirmed a retained viscosity above 85 mPa·s, a broken-gel residue concentration below 200 mg/L, and a core-damage rate under 20%. In field trials at a certain oil field, the proposed system was compared with a conventional organoboron crosslinker system. Throughout the operation, the slurry rate remained stable at 1,000 L/min. During the proppant-transport stage, the average proppant ratio reached 21.7%, with a peak of 45%. The treating pressure was stable and approximately 6.3% lower than that of the control well. The target well achieved an initial daily oil production of 2.66 t/d, representing a 45.4% increase compared with the control well. The gel was completely broken down in the flowback fluid, consistent with the low-damage results observed in laboratory tests. This study provides a fracturing-fluid system that combines excellent proppant transport performance with low-damage characteristics for the efficient development of low-permeability tight oil and gas reservoirs.

Zitieren

APA

Zhou, X., Zhao, Z., Hu, M., Chen, T., Xiong, J., Chen, L., Xu, D., Sun, X., Jia, W., & Hou, Y. (2026). Ultralow Concentration Guar Gum Fracturing Fluid System with Ultrahigh Proppant Concentration. SPE Journal, 31(08), 5370-5389. https://doi.org/10.2118/233789-pa

Vancouver

Zhou X, Zhao Z, Hu M, Chen T, Xiong J, Chen L, et al. Ultralow Concentration Guar Gum Fracturing Fluid System with Ultrahigh Proppant Concentration. SPE Journal. 2026;31(08):5370-5389. doi:10.2118/233789-pa

BibTeX
@article{Zhou2026,
  author = {Zhou, Xuge and Zhao, Zhongcong and Hu, Mingjia and Chen, Tengfei and Xiong, Junjie and Chen, Lifeng and Xu, Depei and Sun, Xiaohui and Jia, Wendong and Hou, Yanxin},
  title = {Ultralow Concentration Guar Gum Fracturing Fluid System with Ultrahigh Proppant Concentration},
  journal = {SPE Journal},
  year = {2026},
  volume = {31},
  number = {08},
  pages = {5370--5389},
  doi = {10.2118/233789-pa}
}
Kostenlos starten →