EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

Flatback Deformity and Stiff Pelvic Mobility Alter the Optimal Cup Anteversion After Total Hip Arthroplasty

Flatback-Deformität und steife pelvine Mobilität verändern die optimale Pfannenanteversion nach Totalendoprothese der Hüfte

Toshiki Konishi iD, Satoshi Hamai iD, Hidehiko Higaki, Shinya Kawahara iD, Ryosuke Yamaguchi iD, Goro Motomura iD, Takeshi Utsunomiya iD, Kenji Kitamura, Soichiro Yoshino iD, Satoru Ikebe iD, Yuki Nakao iD, Takahiro Inoue iD und 2 weitere

JBJS Open Access · 2026-04 · 11 (2)

DOI: 10.2106/jbjs.oa.26.00056 ↗

Auf einen Blick

Bei 108 Hüften beeinflussten Flatback-Deformität und steife spinopelvine Mobilität die optimale Pfannenanteversion nach Hüft-TEP. Flatback war mit niedrigerem CA_mid verbunden, steife SPM mit engerem CA_range.

Fragestellung

Welcher patientenspezifische Bereich der Pfannenanteversion ist mit spinopelvinen Auffälligkeiten nach Hüft-TEP verbunden?

Methode

Retrospektive Kohortenstudie; Analyse der postoperativen Sit-to-stand-Bewegung mit 3D-zu-2D-Model-Image-Registration; virtuelle Positionierung der Implantate bei 40° Inklination.

Ergebnisse

108 Hüften. Flatback: niedrigeres CA_mid als normal (41,1° vs. 46,8°). Steife SPM: ähnliches CA_mid, aber engeres CA_range (14,5° vs. 19,4°). Spinopelvine Ausrichtung korrelierte mit CA-Parametern.

Schlussfolgerung der Autor:innen

Die spinopelvine Ausrichtung beeinflusst die optimale Pfannenorientierung und ihren Toleranzbereich. Die Berücksichtigung dieser Faktoren kann eine patientenspezifische Optimierung der Azetabulumposition ermöglichen.

Kernaussagen

  • Flatback war mit niedrigerem CA_mid verbunden.
  • Steife SPM zeigte ein engeres CA_range.
  • Spinopelvine Parameter korrelierten mit CA-Parametern.

Deutsche Zusammenfassung: KI-gestützt aus dem Original-Abstract erstellt; alle Zahlen wurden automatisch mit dem Original abgeglichen. Maßgeblich ist der Original-Abstract.

Kurz gefasst

Fachartikel in der Zeitschrift JBJS Open Access, 2026-04. Verfasst von Toshiki Konishi und 13 weiteren Autor:innen. Beteiligte Einrichtung: Department of Orthopaedic Surgery, Graduate School of Medical Sciences, Kyushu University, Fukuoka, Japan. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 30 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: Japan Society for the Promotion of Science.

Auf einen BlickAbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Background

Flatback deformity and stiff spinopelvic mobility (SPM) are recognized risk factors for dislocation after total hip arthroplasty. This study aimed to determine patient-specific optimal cup anteversion ranges associated with spinopelvic abnormalities.

Methods

We analyzed postoperative sit-to-stand motion in 108 hips using three-dimensional-to-two-dimensional model-image registration. Implanted components were virtually positioned at their actual positions with inclination at 40°. Using pelvic tilt at maximal anterior tilt and standing, the range of combined anteversion (CA) satisfying required range of motion was evaluated. CA midpoint (CA_mid) and range (CA_range) were compared across spinopelvic alignment groups.

Results

Flatback hips demonstrated a significantly lower CA_mid than normal (41.1° vs. 46.8°), whereas stiff SPM hips showed a similar CA_mid but a narrower CA_range (14.5° vs. 19.4°). Significant correlations were observed between spinopelvic alignment and CA parameters.

Conclusions

Spinopelvic alignment influences both the optimal cup orientation and its tolerance range. Incorporating these factors may allow patient-specific optimization of acetabular component positioning. Level of Evidence: Level III , retrospective cohort study. See Instructions for Authors for a complete description of levels of evidence. Clinical Relevance: Personalized component positioning based on dynamic spinopelvic alignment may help reduce dislocation risk and improve implant stability in high-risk THA patients.

Autor:innen und Institutionen

  • Department of Orthopaedic Surgery, Graduate School of Medical Sciences, Kyushu University, Fukuoka, Japan.
  • Department of Artificial Joints and Biomaterials, Faculty of Medical Sciences, Kyushu University, Fukuoka, Japan.
  • Department of Life Science, Faculty of Life Science, Kyushu Sangyo University, Fukuoka, Japan.
  • Department of Information Science and Engineering, Graduate School of Sciences and Technology for Innovation, Yamaguchi University, Ube, Yamaguchi, Japan.

ORCID-Profile: Toshiki Konishi, Satoshi Hamai, Shinya Kawahara, Ryosuke Yamaguchi, Goro Motomura, Takeshi Utsunomiya, Soichiro Yoshino, Satoru Ikebe, Yuki Nakao, Takahiro Inoue, Wataru Uehara

Förderung

  • Japan Society for the Promotion of Science

Zitieren

APA

Konishi, T., Hamai, S., Higaki, H., Kawahara, S., Yamaguchi, R., Motomura, G., Utsunomiya, T., Kitamura, K., Yoshino, S., Ikebe, S., Nakao, Y., Inoue, T., Uehara, W., & Nakashima, Y. (2026). Flatback Deformity and Stiff Pelvic Mobility Alter the Optimal Cup Anteversion After Total Hip Arthroplasty. JBJS Open Access, 11(2). https://doi.org/10.2106/jbjs.oa.26.00056

Vancouver

Konishi T, Hamai S, Higaki H, Kawahara S, Yamaguchi R, Motomura G, et al. Flatback Deformity and Stiff Pelvic Mobility Alter the Optimal Cup Anteversion After Total Hip Arthroplasty. JBJS Open Access. 2026;11(2). doi:10.2106/jbjs.oa.26.00056

BibTeX
@article{Konishi2026,
  author = {Konishi, Toshiki and Hamai, Satoshi and Higaki, Hidehiko and Kawahara, Shinya and Yamaguchi, Ryosuke and Motomura, Goro and Utsunomiya, Takeshi and Kitamura, Kenji and Yoshino, Soichiro and Ikebe, Satoru and Nakao, Yuki and Inoue, Takahiro and Uehara, Wataru and Nakashima, Yasuharu},
  title = {Flatback Deformity and Stiff Pelvic Mobility Alter the Optimal Cup Anteversion After Total Hip Arthroplasty},
  journal = {JBJS Open Access},
  year = {2026},
  volume = {11},
  number = {2},
  doi = {10.2106/jbjs.oa.26.00056}
}
Kostenlos starten →