EUVIMEDEUVIMED entdecken
Crossref

Effect of change in worktop height on postural deviation during standing cutting task

Adeleye A.A., Akanbi O.G.

International Journal of Scientific Research and Management (IJSRM) · 2026 · 14 (07) · 2960-2969

DOI: 10.18535/ijsrm/v14i07.ec4 ↗

Kurz gefasst

Fachartikel in der Zeitschrift International Journal of Scientific Research and Management (IJSRM), 2026. Verfasst von Adeleye A.A. und 1 weiteren Autor:innen.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Every task performance on a worktop requires coordinated movements of the upper extremities and the trunk. Studies on crab sorting and meat cutting have shown that the alteration of this worktop height changes the mechanical loadings of the musculo skeletal system. However, this information on fabric cutting task is scarce. Hence, this study that investigated how variations in table height influenced the biomechanical loads and kinematics of the neck, shoulder, elbow, wrist and trunk of the table users during cutting task. Twenty-four participants performed simulated fabric cutting tasks while angular deviation of 12 chosen anatomical regions were measured using an inertia measurement unit (Xsens motion capture system). Each participant carried out 24 cutting tasks of the same pattern on two fabric types using four different manual scissors on three different table heights (33" low - WH1, 36" medium - WH2 and 39" high - WH3). The collected angular data with duration was later analyzed. The ANOVA statistics showed that worktop height significantly affected task duration and almost all measured joint movements. Significant effects were observed for shoulder movements (UA1, UA2), elbow movements (LA1, LA2). Wrist radial/ulnar deviation (W2), wrist pronation/supination (WT1), neck movements (N1, N2, N3) and trunk movements (T1, T2, T3), with all p-values less than 0.05. Among all variables, trunk lateral bending (T1) exhibited the highest F-value (413.261), indicating that trunk posture was the most strongly influenced by the changes in worktop height. Shoulder flexion (UA1) and elbow abduction/adduction (LA2) also showed very large F-values, demonstrating substantial postural adaptation of the upper extremities. However, the wrist flexion/extension (W1) (p = 0.224) was the only part that was not significantly affected by the worktop height change. The crucial role of worktop height in the musculoskeletal strain of the neck, shoulder, elbow, wrist and trunk was therefore established as a function of the change in worktop height during cutting task.

Zitieren

APA

A.A., A., & O.G., A. (2026). Effect of change in worktop height on postural deviation during standing cutting task. International Journal of Scientific Research and Management (IJSRM), 14(07), 2960-2969. https://doi.org/10.18535/ijsrm/v14i07.ec4

Vancouver

A.A. A, O.G. A. Effect of change in worktop height on postural deviation during standing cutting task. International Journal of Scientific Research and Management (IJSRM). 2026;14(07):2960-2969. doi:10.18535/ijsrm/v14i07.ec4

BibTeX
@article{AA2026,
  author = {A.A., Adeleye and O.G., Akanbi},
  title = {Effect of change in worktop height on postural deviation during standing cutting task},
  journal = {International Journal of Scientific Research and Management (IJSRM)},
  year = {2026},
  volume = {14},
  number = {07},
  pages = {2960--2969},
  doi = {10.18535/ijsrm/v14i07.ec4}
}
Kostenlos starten →