EUVIMEDEUVIMED entdecken
Crossref

The Fit Consideration of the Denture Manufactured by 3D Printing and Sintering

Shinn-Liang Chang, Cheng-Hsun Lo, Cho-Pei Jiang, Dai-Jia Juan

International Journal of Pharma Medicine and Biological Sciences · 2015

DOI: 10.18178/ijpmbs.4.3.184-187 ↗

Kurz gefasst

Fachartikel in der Zeitschrift International Journal of Pharma Medicine and Biological Sciences, 2015. Verfasst von Shinn-Liang Chang und 3 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In previous study, the shrinkage rate of denture was investigated, and the denture was fixed on the standard mold successfully.However, the shrinkage at the bottom of denture is most important to fit the tooth properly.If the fitness isn't close enough, the bacterial will get into aperture easily to make the teeth being decayed again.It will make the teeth to be removed completely.In this paper, the cross section of the denture is measured and compared through the 3D printing and sintered to study the fit on the standard mold.The shrinkage rates are then obtained along different directions.The results can be applied to amplify the model of denture for the 3D printing to make the denture more close to the mold.

Zitieren

APA

Chang, S., Lo, C., Jiang, C., & Juan, D. (2015). The Fit Consideration of the Denture Manufactured by 3D Printing and Sintering. International Journal of Pharma Medicine and Biological Sciences. https://doi.org/10.18178/ijpmbs.4.3.184-187

Vancouver

Chang S, Lo C, Jiang C, Juan D. The Fit Consideration of the Denture Manufactured by 3D Printing and Sintering. International Journal of Pharma Medicine and Biological Sciences. 2015. doi:10.18178/ijpmbs.4.3.184-187

BibTeX
@article{Chang2015,
  author = {Chang, Shinn-Liang and Lo, Cheng-Hsun and Jiang, Cho-Pei and Juan, Dai-Jia},
  title = {The Fit Consideration of the Denture Manufactured by 3D Printing and Sintering},
  journal = {International Journal of Pharma Medicine and Biological Sciences},
  year = {2015},
  doi = {10.18178/ijpmbs.4.3.184-187}
}
Kostenlos starten →