Thermal mapping with unmanned aerial vehicles for substations: infrared orthomosaics and early detection of hot spots
Latin American Developments in Energy Engineering · 26.06.2026 · 7 (1)
DOI: 10.17981/ladee.07.01.2026.2 ↗Kurz gefasst
Fachartikel in der Zeitschrift Latin American Developments in Energy Engineering, online erschienen am 26.06.2026. Verfasst von Andrés Daniel Prieto Martinez und 4 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).
Abstract (Originalsprache)
This study presents a workflow for thermographic photogrammetric inspection of electrical substations using an unmanned aerial vehicle (UAV) equipped with co-mounted visible-light and thermal cameras. Overlapping aerial imagery was acquired during autonomous missions and processed using open-source photogrammetry to generate orthophotos and 3D products, followed by thermal anomaly screening via automated thresholding and targeted image analysis. Field trials at a test site and an operating distribution substation produced complete datasets in both modalities; the substation campaign comprised 32 visible and 55 thermal images (scene area ≈ 0.51 ha) with ~80% overlaps. Achieved ground sampling distances were ≈ 0.70 cm (visible) and ≈ 3.3 cm (thermal) at the substation, and ≈ 2.7 cm (visible) and ≈ 8.2 cm (thermal) at the test site. The workflow yielded orthophotos that support rapid identification of candidate hotspots; 3D reconstruction from visible imagery was acceptable, whereas thermal 3D products were constrained by sensor resolution and nadir-only capture. Electromagnetic interference in the substation environment caused significant magnetic-field deviations (up to 500 units, compared with the nominal 100-200 units), affecting flight stability and requiring 30 m altitude adjustments to mitigate the effects. Additional practical limitations included reflectance artifacts on ceramic/metal surfaces and the use of a non-radiometric thermal sensor, which provides relative rather than absolute temperature readings. Despite these constraints, the approach demonstrates a viable, low-risk, and efficient alternative for preventive substation inspection using accessible, open-source tooling and points to clear future research directions, including the use of radiometric sensors, gimballed or oblique thermal capture, thermal-optimized photogrammetric processing, and validation across substations with different configurations and operating conditions.
Zitieren
APA
Martinez, A. D. P., Moreno, I. E. R., Hasse, A., Paiva, E., & Rodas, J. (2026). Thermal mapping with unmanned aerial vehicles for substations: infrared orthomosaics and early detection of hot spots. Latin American Developments in Energy Engineering, 7(1). https://doi.org/10.17981/ladee.07.01.2026.2
Vancouver
Martinez ADP, Moreno IER, Hasse A, Paiva E, Rodas J. Thermal mapping with unmanned aerial vehicles for substations: infrared orthomosaics and early detection of hot spots. Latin American Developments in Energy Engineering. 2026;7(1). doi:10.17981/ladee.07.01.2026.2
BibTeX
@article{Martinez2026,
author = {Martinez, Andrés Daniel Prieto and Moreno, Iván Enrique Rodríguez and Hasse, Andreas and Paiva, Enrique and Rodas, Jorge},
title = {Thermal mapping with unmanned aerial vehicles for substations: infrared orthomosaics and early detection of hot spots},
journal = {Latin American Developments in Energy Engineering},
year = {2026},
volume = {7},
number = {1},
doi = {10.17981/ladee.07.01.2026.2}
}
EUVIMED