EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Structural Redesign and Finite Element Assessment of an EOT Crane End Carriage with Experimental Validation and Economic Evaluation

Rajeshkumar Kalubhai Detroja

Journal of Intelligent Decision Making and Information Science · 29.08.2026 · 3 (3) · 77-92

DOI: 10.17762/jidmis.v3.5535 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Intelligent Decision Making and Information Science, online erschienen am 29.08.2026. Verfasst von Rajeshkumar Kalubhai Detroja. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Electric Overhead Traveling (EOT) cranes are widely used in manufacturing, warehousing, steel plants, and material-handling industries. The end carriage is a critical structural component that supports the bridge girder and enables longitudinal movement of the crane along the runway beams. Although extensive research has addressed crane girder design, relatively little attention has been given to the structural optimization of end carriage assemblies. This study investigates the redesign and optimization of an EOT crane end carriage with the objective of reducing structural height, material consumption, and overall project cost while maintaining acceptable stress and deflection limits. Analytical design calculations were performed following conventional crane design practice and relevant standards. Finite Element Analysis (FEA) was conducted in ANSYS under a static load of 245.17 kN, representing the maximum operational loading condition, for both a conventional box-section end carriage and an optimized folded-plate (chevron/W-shaped) configuration modelled in Creo Simulate. The conventional design showed a maximum deformation of 1.14 mm and a maximum von Mises stress of 250 MPa, corresponding to a factor of safety of approximately 1.5 against the yield strength of IS 2062 Grade B steel. The optimized configuration reduced the structural height by approximately 300 mm, with a maximum deformation of 2.11 mm and a maximum von Mises stress of 250.00 MPa, corresponding to a factor of safety of approximately 1.5 against the same yield strength — a technically safe but slim margin that would benefit from a small design refinement (such as a fillet radius at the fold) to provide more comfortable headroom. The associated reduction in shed height would still lower construction cost by an estimated INR 1.26 million. This work provides a practical framework for optimizing crane support structures for industrial applications.

Zitieren

APA

Detroja, R. K. (2026). Structural Redesign and Finite Element Assessment of an EOT Crane End Carriage with Experimental Validation and Economic Evaluation. Journal of Intelligent Decision Making and Information Science, 3(3), 77-92. https://doi.org/10.17762/jidmis.v3.5535

Vancouver

Detroja RK. Structural Redesign and Finite Element Assessment of an EOT Crane End Carriage with Experimental Validation and Economic Evaluation. Journal of Intelligent Decision Making and Information Science. 2026;3(3):77-92. doi:10.17762/jidmis.v3.5535

BibTeX
@article{Detroja2026,
  author = {Detroja, Rajeshkumar Kalubhai},
  title = {Structural Redesign and Finite Element Assessment of an EOT Crane End Carriage with Experimental Validation and Economic Evaluation},
  journal = {Journal of Intelligent Decision Making and Information Science},
  year = {2026},
  volume = {3},
  number = {3},
  pages = {77--92},
  doi = {10.17762/jidmis.v3.5535}
}
Kostenlos starten →