EUVIMEDEUVIMED entdecken
Crossref

ADDITIVE MANUFACTURING OF ARCHITECTED INCONEL 718 STRUCTURES: EXPLORING THE STRENGTH AND FAILURE OF LATTICE STRUCTURES

Sami Westman, Ahmed Abdelghany, Mahmoud Khedr, Lari Rajala, Ilkka Poutiainen, Antti Järvenpää

Materiali in tehnologije · 04.06.2026 · 60 (3)

DOI: 10.17222/mit.2025.1578 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materiali in tehnologije, online erschienen am 04.06.2026. Verfasst von Sami Westman und 5 weiteren Autor:innen.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study investigates the mechanical performance and failure behaviour of additively manufactured Inconel 718 (IN718) lattice structures fabricated via laser powder bed fusion (PBF-LB). Five distinct unit-cell topologies were evaluated: three triply periodic minimal surfaces (TPMSs), namely Schoen gyroid (SG), Schwarz diamond (SD), and Schwarz primitive (SP), and two beam-based strut lattices with body-centred cubic (BCC) and beam diamond (BD) unit cells. All specimens were fabricated on an EOS M290 system with a controlled infill density of approximately 18–20 % and subjected to the manufacturer-recommended solution and ageing heat treatment for IN718. Monotonic tensile tests were performed to quantify the ultimate tensile strength (UTS) and to evaluate topology-dependent failure mechanisms. The results reveal a pronounced architectural influence on tensile performance, with TPMS lattices consistently outperforming beam-based designs. Among all configurations, the SD lattice achieved the highest UTS, reaching approximately 817 MPa, whereas the BCC lattice exhibited the lowest UTS, 315 MPa. Fractographic analysis showed that beam-based structures failed predominantly at strut–node intersections, while TPMS lattices displayed micro-void coalescence with local shear facets, indicative of distributed ductile tearing. Overall, the results indicate that TPMS geometries exhibit superior tensile performance compared with conventional beam lattices in static load-bearing applications.

Zitieren

APA

Westman, S., Abdelghany, A., Khedr, M., Rajala, L., Poutiainen, I., & Järvenpää, A. (2026). ADDITIVE MANUFACTURING OF ARCHITECTED INCONEL 718 STRUCTURES: EXPLORING THE STRENGTH AND FAILURE OF LATTICE STRUCTURES. Materiali in tehnologije, 60(3). https://doi.org/10.17222/mit.2025.1578

Vancouver

Westman S, Abdelghany A, Khedr M, Rajala L, Poutiainen I, Järvenpää A. ADDITIVE MANUFACTURING OF ARCHITECTED INCONEL 718 STRUCTURES: EXPLORING THE STRENGTH AND FAILURE OF LATTICE STRUCTURES. Materiali in tehnologije. 2026;60(3). doi:10.17222/mit.2025.1578

BibTeX
@article{Westman2026,
  author = {Westman, Sami and Abdelghany, Ahmed and Khedr, Mahmoud and Rajala, Lari and Poutiainen, Ilkka and Järvenpää, Antti},
  title = {ADDITIVE MANUFACTURING OF ARCHITECTED INCONEL 718 STRUCTURES: EXPLORING THE STRENGTH AND FAILURE OF LATTICE STRUCTURES},
  journal = {Materiali in tehnologije},
  year = {2026},
  volume = {60},
  number = {3},
  doi = {10.17222/mit.2025.1578}
}
Kostenlos starten →