EUVIMEDEUVIMED entdecken
Crossref

Influence of raster angle on mechanical properties for FDM 3D-printed PLA polymer

Tarun Kumar Gupta, Nagireddy Mounika, Ambuj Saxena, Nagendra Kumar Maurya, Megha Jagga, Gourav Sood

Green Materials · 05.08.2026 · 14 (3) · 206-215

DOI: 10.1680/jgrma.24.00212 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Green Materials, online erschienen am 24.03.2025. Verfasst von Tarun Kumar Gupta und 5 weiteren Autor:innen. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 26 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In the present work, the influence of raster angle (0°, 45°, and 90°) on the mechanical properties of 3D-printed polylactic acid has been investigated. Tensile, hardness, and impact tests were conducted for the same. Furthermore, dynamic mechanical analysis has also been conducted. The results revealed that the mechanical properties of specimens printed at a 0° raster angle are better than the specimens printed at other raster angles. Furthermore, dynamic mechanical analysis exposed that the storage modulus is higher for the specimen printed at a 0° raster angle, and the loss tangent (tan δ) is higher for the specimen printed at a 90° raster angle. The yield strength of 45° and 90° raster angles was 7.12% and 19.74% less than the 0° raster angle, respectively. The ultimate tensile strength of 45° and 90° raster angles was 6.46% and 19.10% less than the 0° raster angle, respectively. The 0° printed specimen exhibited maximum impact strength (45 kJ/m2), hardness (17.45 HV), and flexural strength (64.77 MPa), followed by 45° and 90° specimens. Furthermore, the fracture strain was less than 6% for 45° and 90° raster angles at the comparison of 0° raster angle.

Zitieren

APA

Gupta, T. K., Mounika, N., Saxena, A., Maurya, N. K., Jagga, M., & Sood, G. (2026). Influence of raster angle on mechanical properties for FDM 3D-printed PLA polymer. Green Materials, 14(3), 206-215. https://doi.org/10.1680/jgrma.24.00212

Vancouver

Gupta TK, Mounika N, Saxena A, Maurya NK, Jagga M, Sood G. Influence of raster angle on mechanical properties for FDM 3D-printed PLA polymer. Green Materials. 2026;14(3):206-215. doi:10.1680/jgrma.24.00212

BibTeX
@article{Gupta2026,
  author = {Gupta, Tarun Kumar and Mounika, Nagireddy and Saxena, Ambuj and Maurya, Nagendra Kumar and Jagga, Megha and Sood, Gourav},
  title = {Influence of raster angle on mechanical properties for FDM 3D-printed PLA polymer},
  journal = {Green Materials},
  year = {2026},
  volume = {14},
  number = {3},
  pages = {206--215},
  doi = {10.1680/jgrma.24.00212}
}
Kostenlos starten →