EUVIMEDEUVIMED entdecken
Crossref

Centrifuge modelling of the installation and uplift of helical anchors in clay

Zeliang Li, Yinghui Tian, Shubhrajit Maitra, Mark J. Cassidy, Christophe Gaudin

Géotechnique · 05.11.2026 · 76 (11) · 1297-1310

DOI: 10.1680/jgeot.25.00733 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Géotechnique, online erschienen am 22.09.2026. Verfasst von Zeliang Li und 4 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 50 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study investigates the installation and uplift behaviour of helical anchors in clay through 14 centrifuge tests at 80g. For each test, the helical anchor was installed at a specified advancement ratio (AR), defined as the ratio of vertical penetration per revolution to helix pitch, and was then subjected to either immediate uplift or uplift after full consolidation. The test results show that the required vertical force decreased with reducing AR, and the helical anchor was under tension for AR ≤0·75. The required torque increased by 137·5% as AR reduced from 3 to 0·5, then fell slightly at lower ARs. The immediate holding capacity exhibits a maximum value at AR = 0·9, whereas the consolidated holding capacity increases with AR because of greater post-consolidation strength gain. Excess pore pressures above and below the helix were monitored. Installation consistently generated positive excess pore pressure above the helix, peaking at AR = 0·9, while the pore pressure beneath the helix diminished with reducing AR. During uplift, the difference between the excess pore pressures above and below the helix closely correlated with the uplift resistance. The findings provide guidance for the design of helical anchors and optimisation of installation equipment.

Zitieren

APA

Li, Z., Tian, Y., Maitra, S., Cassidy, M. J., & Gaudin, C. (2026). Centrifuge modelling of the installation and uplift of helical anchors in clay. Géotechnique, 76(11), 1297-1310. https://doi.org/10.1680/jgeot.25.00733

Vancouver

Li Z, Tian Y, Maitra S, Cassidy MJ, Gaudin C. Centrifuge modelling of the installation and uplift of helical anchors in clay. Géotechnique. 2026;76(11):1297-1310. doi:10.1680/jgeot.25.00733

BibTeX
@article{Li2026,
  author = {Li, Zeliang and Tian, Yinghui and Maitra, Shubhrajit and Cassidy, Mark J. and Gaudin, Christophe},
  title = {Centrifuge modelling of the installation and uplift of helical anchors in clay},
  journal = {Géotechnique},
  year = {2026},
  volume = {76},
  number = {11},
  pages = {1297--1310},
  doi = {10.1680/jgeot.25.00733}
}
Kostenlos starten →