EUVIMEDEUVIMED entdecken
Crossref

Influence of RHA reinforcements on mechanical and wear behavior of Al 4032 composites

Avinash Gudimetla, Surapaneni Sambhu Prasad, Dumpala Lingaraju

Emerging Materials Research · 01.12.2020 · 9 (4) · 1237-1249

DOI: 10.1680/jemmr.20.00104 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Emerging Materials Research, erschienen am 01.12.2020. Verfasst von Avinash Gudimetla und 2 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 48 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study was aimed at developing low-cost composites with high specific strength and better performance by incorporating agro-waste as reinforcements. The stir-casting technique was adopted for fabricating composites with aluminum (Al) 4032 as matrix material and 0, 2, 4 and 6 wt.% rice husk ash (RHA) as reinforcements. The mechanical properties of the produced composites were investigated, and the wear rate under dry conditions was also experimented on, to assess the characteristics of the produced composites. Energy-dispersive X-ray spectroscopy and scanning electron microscopy analyses were done to study the presence and distribution of reinforcements in the matrix material. The surface of specimens after wear test was analyzed from optical microscope images. The influence of process parameters such as reinforcement (wt.%), speed (revolutions per min (rpm)) and load (N) on wear rate was identified, and the parameters were optimized for minimum wear rate using a Taguchi L 16 orthogonal array. The percentage contribution of process parameters was obtained by performing analysis of variance. Better results were obtained for composites with 6 wt.% RHA with 84 HRB, 92.30 HV, ultimate tensile strength of 383.73 MPa and ultimate compressive strength of 571.6 MPa. Minimum wear rate was obtained for composites with 6 wt.% RHA at 100 rpm and 10 N. Speed was found to be the most contributing factor, with 72.94%, followed by load, with 13.34%, and weight percentage of reinforcements, with 11.88%.

Zitieren

APA

Gudimetla, A., Prasad, S. S., & Lingaraju, D. (2020). Influence of RHA reinforcements on mechanical and wear behavior of Al 4032 composites. Emerging Materials Research, 9(4), 1237-1249. https://doi.org/10.1680/jemmr.20.00104

Vancouver

Gudimetla A, Prasad SS, Lingaraju D. Influence of RHA reinforcements on mechanical and wear behavior of Al 4032 composites. Emerging Materials Research. 2020;9(4):1237-1249. doi:10.1680/jemmr.20.00104

BibTeX
@article{Gudimetla2020,
  author = {Gudimetla, Avinash and Prasad, Surapaneni Sambhu and Lingaraju, Dumpala},
  title = {Influence of RHA reinforcements on mechanical and wear behavior of Al 4032 composites},
  journal = {Emerging Materials Research},
  year = {2020},
  volume = {9},
  number = {4},
  pages = {1237--1249},
  doi = {10.1680/jemmr.20.00104}
}
Kostenlos starten →