Specifics of carbonitriding-based strengthening of tool steels for pipe-making tools
Theory and Practice of Metallurgy · 30.09.2026 · (3) · 70-79
DOI: 10.15802/tpm.3.2026.08 ↗Kurz gefasst
Fachartikel in der Zeitschrift Theory and Practice of Metallurgy, online erschienen am 30.09.2026. Verfasst von L. M. Deineko und 4 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
This study presents CFD modeling of fluid flow in a cooler intended for sampling from an airlift fermenter. The investigation concentrates on the hydraulic and thermal behavior of a tube-in-tube cooler. Boundary conditions and fluid properties were defined from experimental measurements supplied by the client together with the available cooling-water conditions. The objective is to develop a comprehensive picture of cooler performance for the proposed geometry, which was established from balance calculations and the client's requirements. The CFD analysis considers different cooling-water inlet arrangements and examines the effect of obstacles (swirl generators) installed in the annular cooling-water region to enhance heat transfer during cooling of the sampled medium. Because the cooling medium moves at a very low velocity, particular attention is given to disturbing the laminar boundary layer in the heat-transfer zone.
Zitieren
APA
Deineko, L. M., Pinchuk, V. L., Kryvchyk, L. S., Panchenko, A. V., & Nosenko, V. K. (2026). Specifics of carbonitriding-based strengthening of tool steels for pipe-making tools. Theory and Practice of Metallurgy, 70-79. https://doi.org/10.15802/tpm.3.2026.08
Vancouver
Deineko LM, Pinchuk VL, Kryvchyk LS, Panchenko AV, Nosenko VK. Specifics of carbonitriding-based strengthening of tool steels for pipe-making tools. Theory and Practice of Metallurgy. 2026:70-79. doi:10.15802/tpm.3.2026.08
BibTeX
@article{Deineko2026,
author = {Deineko, L. M. and Pinchuk, V. L. and Kryvchyk, L. S. and Panchenko, A. V. and Nosenko, V. K.},
title = {Specifics of carbonitriding-based strengthening of tool steels for pipe-making tools},
journal = {Theory and Practice of Metallurgy},
year = {2026},
number = {3},
pages = {70--79},
doi = {10.15802/tpm.3.2026.08}
}
EUVIMED