CFD Analysis of flow and heat transfer in a sampling cooler for an airlift fermenter
Theory and Practice of Metallurgy · 30.09.2026 · (3) · 60-69
DOI: 10.15802/tpm.3.2026.07 ↗Kurz gefasst
Fachartikel in der Zeitschrift Theory and Practice of Metallurgy, online erschienen am 30.09.2026. Verfasst von M. Rimár und 4 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
This study presents CFD modeling of fluid flow in a cooler intended for sampling from an airlift fermenter. The investigation concentrates on the hydraulic and thermal behavior of a tube-in-tube cooler. Boundary conditions and fluid properties were defined from experimental measurements supplied by the client together with the available cooling-water conditions. The objective is to develop a comprehensive picture of cooler performance for the proposed geometry, which was established from balance calculations and the client's requirements. The CFD analysis considers different cooling-water inlet arrangements and examines the effect of obstacles (swirl generators) installed in the annular cooling-water region to enhance heat transfer during cooling of the sampled medium. Because the cooling medium moves at a very low velocity, particular attention is given to disturbing the laminar boundary layer in the heat-transfer zone.
Zitieren
APA
Rimár, M., Kizek, J., Kulikov, A., Fedák, M., & Šmajda, M. (2026). CFD Analysis of flow and heat transfer in a sampling cooler for an airlift fermenter. Theory and Practice of Metallurgy, 60-69. https://doi.org/10.15802/tpm.3.2026.07
Vancouver
Rimár M, Kizek J, Kulikov A, Fedák M, Šmajda M. CFD Analysis of flow and heat transfer in a sampling cooler for an airlift fermenter. Theory and Practice of Metallurgy. 2026:60-69. doi:10.15802/tpm.3.2026.07
BibTeX
@article{Rimr2026,
author = {Rimár, M. and Kizek, J. and Kulikov, A. and Fedák, M. and Šmajda, M.},
title = {CFD Analysis of flow and heat transfer in a sampling cooler for an airlift fermenter},
journal = {Theory and Practice of Metallurgy},
year = {2026},
number = {3},
pages = {60--69},
doi = {10.15802/tpm.3.2026.07}
}
EUVIMED