EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC 4.0

Design and manufacturing of a passive prosthetic knee joint

Fahad Mohanad Kadhim, Mais O. Al−saffar, Noor Ali Sadek, Reem Shakir Mahmood

International Review of Applied Sciences and Engineering · 05.11.2026 · 17 (3) · 494-506

DOI: 10.1556/1848.2026.01437 ↗

Kurz gefasst

Fachartikel in der Zeitschrift International Review of Applied Sciences and Engineering, erschienen am 05.11.2026. Verfasst von Fahad Mohanad Kadhim und 3 weiteren Autor:innen. Die Arbeit nennt 33 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Passive prosthetic knee joints remain an attractive solution for transfemoral amputees in low-resource settings because of their low cost, mechanical simplicity, and ease of maintenance. But there are numerous commercial designs which are either relatively heavy or mechanically complex. In this work, the design, finite element analysis, material selection and fabrication of a lightweight passive prosthetic knee joint with a simple polycentric mechanism are proposed. Three candidate materials (AISI 4130 steel, Al2024-T4 and Al7075-T651) were selected and experimentally characterized by tensile testing and numerically compared in terms of stress distribution, deformation, weight and factor of safety and subjected to an extreme static loading of 1000 N. The maximum of von Mises stress obtained from the finite element calculations for all materials studied was 40.2 MPa, which was found to be below their respective yield strengths, thus providing sufficient structural integrity. Al7075-T651 was found to have the highest factor of safety (12.19), minimum structural deformation (0.0497 mm) and a good strength-to-weight ratio, thus showing the best overall performance among the materials evaluated, and the least prototype weight (198 g). The prototype weight was measured and compared with the CAD weight prediction (195 g), and good agreement was obtained with the fabricated prototype (198 g), with a deviation of 1.5%. This agreement indicates that the overall geometry, volume and assigned material density are consistent in the CAD model. The entire prototype was produced at an estimated cost of about USD 160, which is considerably less expensive than many passive prosthetic knee joints on the market. This proposed design is lightweight, has sufficient structural strength, a simple mechanical structure, and a low manufacturing cost, which make it a promising alternative for making transfemoral prostheses, especially in developing and resource-limited countries.

Zitieren

APA

Kadhim, F. M., Al−saffar, M. O., Sadek, N. A., & Mahmood, R. S. (2026). Design and manufacturing of a passive prosthetic knee joint. International Review of Applied Sciences and Engineering, 17(3), 494-506. https://doi.org/10.1556/1848.2026.01437

Vancouver

Kadhim FM, Al−saffar MO, Sadek NA, Mahmood RS. Design and manufacturing of a passive prosthetic knee joint. International Review of Applied Sciences and Engineering. 2026;17(3):494-506. doi:10.1556/1848.2026.01437

BibTeX
@article{Kadhim2026,
  author = {Kadhim, Fahad Mohanad and Al−saffar, Mais O. and Sadek, Noor Ali and Mahmood, Reem Shakir},
  title = {Design and manufacturing of a passive prosthetic knee joint},
  journal = {International Review of Applied Sciences and Engineering},
  year = {2026},
  volume = {17},
  number = {3},
  pages = {494--506},
  doi = {10.1556/1848.2026.01437}
}
Kostenlos starten →