EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

Four-Axis CNC Machine with Microcontroller for Cutting Polystyrene with Hot Wire

Helga Silaghi, Viorica Spoială, Simona Veronica Abrudan Caciora, D. Spoială

The Scientific Bulletin of Electrical Engineering Faculty · 2017

DOI: 10.1515/sbeef-2016-0006 ↗

Kurz gefasst

Fachartikel in der Zeitschrift The Scientific Bulletin of Electrical Engineering Faculty, 2017. Verfasst von Helga Silaghi und 3 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 9 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Numerically controlled machines require precise control, because it is always necessary to know the placement of the effector. Control involves the use of electric motors that can be checked with precision. Therefore stepper motors are preferred. A further advance in stepper control is to incorporate a reaction mechanism for the rotor (for example, an encoder) so as communication is optimal for generating the torque, depending on the position of the rotor. This turns the motor into a servo mechanism with very high torque and very good position resolution. An advance in this technique is to operate the motor in a closed loop only if the error of rotor positioning becomes too high. This will allow the system to avoid oscillation while searching for a position, a problem that commonly occurs with servos. The supervision of a numerically controlled tool is limited to the control of electric motors that actuate mechanical assemblies. Control can be implemented by using specialized integrated circuits or microcontrollers. This paper presents a numerically controlled (CNC) machine with microcontroller.

Zitieren

APA

Silaghi, H., Spoială, V., Caciora, S. V. A., & Spoială, D. (2017). Four-Axis CNC Machine with Microcontroller for Cutting Polystyrene with Hot Wire. The Scientific Bulletin of Electrical Engineering Faculty. https://doi.org/10.1515/sbeef-2016-0006

Vancouver

Silaghi H, Spoială V, Caciora SVA, Spoială D. Four-Axis CNC Machine with Microcontroller for Cutting Polystyrene with Hot Wire. The Scientific Bulletin of Electrical Engineering Faculty. 2017. doi:10.1515/sbeef-2016-0006

BibTeX
@article{Silaghi2017,
  author = {Silaghi, Helga and Spoială, Viorica and Caciora, Simona Veronica Abrudan and Spoială, D.},
  title = {Four-Axis CNC Machine with Microcontroller for Cutting Polystyrene with Hot Wire},
  journal = {The Scientific Bulletin of Electrical Engineering Faculty},
  year = {2017},
  doi = {10.1515/sbeef-2016-0006}
}
Kostenlos starten →