Quantitative metallographic characterization of process-dependent pores and cracks in selective laser-melted GH3230 alloy using a TWS-assisted workflow
Practical Metallography · 26.10.2026 · 63 (10) · 650-692
DOI: 10.1515/pm-2026-0065 ↗Kurz gefasst
Fachartikel in der Zeitschrift Practical Metallography, online erschienen am 28.10.2026. Verfasst von P. Zhang und 2 weiteren Autor:innen. Die Arbeit nennt 28 Literaturangaben.
Abstract (Originalsprache)
An independently validated Trainable Weka Segmentation (TWS)-assisted workflow was developed for quantitative metallographic characterization of pores and cracks in selective laser-melted GH3230. Fifty manually annotated micrographs, excluded from classifier development, were used for validation. TWS achieved the highest recall (0.940 ± 0.044) and the lowest relative error in the equivalent crack-width descriptor (6.2 ± 3.9 %), while Otsu thresholding gave a lower area-fraction error. Applied to process and post-processing conditions, the workflow resolved distinct pore/ crack responses to laser power, scanning speed, hatch spacing, scanning strategy, heat treatment, and hot isostatic pressing. Hot isostatic pressing reduced the crack area fraction from 2.328 % to 0.532 %. The workflow provides a reproducible two-dimensional basis for metallographic process screening of GH3230.
Zitieren
APA
Zhang, P., Li, Z., & Liu, C. (2026). Quantitative metallographic characterization of process-dependent pores and cracks in selective laser-melted GH3230 alloy using a TWS-assisted workflow. Practical Metallography, 63(10), 650-692. https://doi.org/10.1515/pm-2026-0065
Vancouver
Zhang P, Li Z, Liu C. Quantitative metallographic characterization of process-dependent pores and cracks in selective laser-melted GH3230 alloy using a TWS-assisted workflow. Practical Metallography. 2026;63(10):650-692. doi:10.1515/pm-2026-0065
BibTeX
@article{Zhang2026,
author = {Zhang, P. and Li, Z. and Liu, C.},
title = {Quantitative metallographic characterization of process-dependent pores and cracks in selective laser-melted GH3230 alloy using a TWS-assisted workflow},
journal = {Practical Metallography},
year = {2026},
volume = {63},
number = {10},
pages = {650--692},
doi = {10.1515/pm-2026-0065}
}
EUVIMED