Outlet Flow Velocity in Circular Culvert
Archives of Hydro-Engineering and Environmental Mechanics · 2014
DOI: 10.1515/heem-2015-0013 ↗Kurz gefasst
Fachartikel in der Zeitschrift Archives of Hydro-Engineering and Environmental Mechanics, 2014. Verfasst von Wojciech Szpakowski. Die Arbeit wurde bisher 2-mal zitiert (Crossref). Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 3.0).
Abstract (Originalsprache)
The outlet flow velocity in the end section of the culvert barrel depends in most cases on the culvert geometry, including the barrel slope, as well as on upstream and downstream channel parameters. Flowing water can create pressure flow or free surface flow in the culvert barrel. In the case of an unsubmerged barrel outlet, the free-surface flow is more frequent than the full flow. Increased velocities can cause channel bed scour and bank erosion downstream of the culvert outlet. Different culvert flow cases in which the barrel outlet is unsubmerged are presented in this paper. The influence of the flow regime on the outlet velocity is also discussed.
Zitieren
APA
Szpakowski, W. (2014). Outlet Flow Velocity in Circular Culvert. Archives of Hydro-Engineering and Environmental Mechanics. https://doi.org/10.1515/heem-2015-0013
Vancouver
Szpakowski W. Outlet Flow Velocity in Circular Culvert. Archives of Hydro-Engineering and Environmental Mechanics. 2014. doi:10.1515/heem-2015-0013
BibTeX
@article{Szpakowski2014,
author = {Szpakowski, Wojciech},
title = {Outlet Flow Velocity in Circular Culvert},
journal = {Archives of Hydro-Engineering and Environmental Mechanics},
year = {2014},
doi = {10.1515/heem-2015-0013}
}
EUVIMED