EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Mathematical modeling and dynamic analysis of the hot aggregate dosing system in asphalt concrete plants

Aleksandr S. Lampadov, Yuliya E. Pleshivtseva, Aleksandr L. Evelev

Vestnik of Samara State Technical University. Technical Sciences Series · 20.07.2026 · 34 (2) · 46-64

DOI: 10.14498/tech.2026.2.3 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Vestnik of Samara State Technical University. Technical Sciences Series, online erschienen am 20.07.2026. Verfasst von Aleksandr S. Lampadov und 2 weiteren Autor:innen. Die Arbeit nennt 16 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Accurate batching of hot mineral aggregates is one of the key factors determining the quality of asphalt concrete mixtures. Batching accuracy is significantly affected by the dynamic characteristics of the pneumatic actuator, transport delay of the falling ma-terial, and the transient response of the weighing system, which complicates the develop-ment of high-performance control algorithms without an adequate mathematical model of the process. This paper presents a comprehensive dynamic model of the aggregate batching process, integrating mathematical models of the pneumatic drive, sector gate opening mechanism, granular material discharge, mass accumulation in the weighing hopper, and the formation of the measured signal of the load-cell weighing system. The model is implemented in MATLAB/Simulink using a modular architecture, which enables independent development and modification of individual subsystems as well as efficient numerical simulation. The model parameters are identified from experimental batching data obtained for different aggregate size fractions. A phenomenological parameter identification approach is employed to estimate parameters that cannot be determined directly from physical measurements. The adequacy of the identified model is quantitatively evaluated using standard error metrics and comparison with experimental transient responses. The proposed model is intended for dynamic analysis of the batching process, parameter identification, and investigation of the influence of technological and design parameters on batching accuracy. In addition, periodic updating of the model parameters using current measurement data enables its application as the computational core of a digital twin for the batching process and provides a foundation for the development of predictive and adaptive control systems.

Zitieren

APA

Lampadov, A. S., Pleshivtseva, Y. E., & Evelev, A. L. (2026). Mathematical modeling and dynamic analysis of the hot aggregate dosing system in asphalt concrete plants. Vestnik of Samara State Technical University. Technical Sciences Series, 34(2), 46-64. https://doi.org/10.14498/tech.2026.2.3

Vancouver

Lampadov AS, Pleshivtseva YE, Evelev AL. Mathematical modeling and dynamic analysis of the hot aggregate dosing system in asphalt concrete plants. Vestnik of Samara State Technical University. Technical Sciences Series. 2026;34(2):46-64. doi:10.14498/tech.2026.2.3

BibTeX
@article{Lampadov2026,
  author = {Lampadov, Aleksandr S. and Pleshivtseva, Yuliya E. and Evelev, Aleksandr L.},
  title = {Mathematical modeling and dynamic analysis of the hot aggregate dosing system in asphalt concrete plants},
  journal = {Vestnik of Samara State Technical University. Technical Sciences Series},
  year = {2026},
  volume = {34},
  number = {2},
  pages = {46--64},
  doi = {10.14498/tech.2026.2.3}
}
Kostenlos starten →