EUVIMEDEUVIMED entdecken
Crossref

Simulation of the styrene production process via catalytic dehydrogenation of ethylbenzene using CHEMCAD® process simulator

Amaury Pérez Sánchez, Eddy Javier Pérez Sánchez, Rutdali María Segura Silva

Tecnura · 2017

DOI: 10.14483/22487638.11499 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Tecnura, 2017. Verfasst von Amaury Pérez Sánchez und 2 weiteren Autor:innen. Die Arbeit wurde bisher 12-mal zitiert (Crossref).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Background

Process simulation has been extensively used in recent years to design, evaluate or optimize processes, systems and specific operations of the chemical industry and its related disciplines. Currently, CHEMCAD® constitute one of the most used process simulators because of the great number of chemical and petrochemical processes that can be simulated.

Method

The simulation of the production process of styrene via catalytic dehydrogenation of ethyl-benzene is carried out by using the process simulator CHEMCAD® version 5.2.0, in order to determine the composition and mass flow-rate of each process involved in the production, as well as the main operating parameters of the equipment used. Two sensitivity studies were carried out: firstly, the influence of the temperature and pressure values applied at the LLV Separator on the amounts of ethyl-benzene and styrene to be obtained by the intermediate and top currents of this equipment; secondly, the influence of the operating pressure of the Distillation Column No. 1 (benzene-toluene column) on the quantity of ethyl-benzene and styrene obtained at the bottom stream. The simulating software MATLAB® version 7.8.0 was used to process the results obtained.

Results

Around 9234.436 kg/h of styrene is obtained in the last distillation column with 99.6% purity. Additionally, it was found that the water is the main impurity found on this stream, which represents 0.35% of the weight.

Conclusions

The LLV Separator must operate at a low temperature (5 – 10 ºC) and at a relatively high pressure (10 bar), whereas the Distillation Column No. 1 must work at a pressure near atmospheric (1.0 bar), or preferably under vacuum conditions in order to obtain the highest yields of styrene and ethyl-benzene.

Zitieren

APA

Sánchez, A. P., Sánchez, E. J. P., & Silva, R. M. S. (2017). Simulation of the styrene production process via catalytic dehydrogenation of ethylbenzene using CHEMCAD® process simulator. Tecnura. https://doi.org/10.14483/22487638.11499

Vancouver

Sánchez AP, Sánchez EJP, Silva RMS. Simulation of the styrene production process via catalytic dehydrogenation of ethylbenzene using CHEMCAD® process simulator. Tecnura. 2017. doi:10.14483/22487638.11499

BibTeX
@article{Snchez2017,
  author = {Sánchez, Amaury Pérez and Sánchez, Eddy Javier Pérez and Silva, Rutdali María Segura},
  title = {Simulation of the styrene production process via catalytic dehydrogenation of ethylbenzene using CHEMCAD® process simulator},
  journal = {Tecnura},
  year = {2017},
  doi = {10.14483/22487638.11499}
}
Kostenlos starten →