EUVIMEDEUVIMED entdecken
ValidierungsstudieOpen Access · CC BY 4.0

Validation and optimisation of wearable accelerometer data pre-processing for digital measure implementation and development

Joss Langford iD, Jia Ying Chua, Ian Long, Alan C Williams, Melvyn Hillsdon

PLOS One · 2026

DOI: 10.1371/journal.pone.0346458 ↗

Kurz gefasst

Validierungsstudie in der Zeitschrift PLOS One, 2026. Verfasst von Joss Langford und 4 weiteren Autor:innen. Beteiligte Einrichtung: Department of Public Health and Sport Sciences, University of Exeter, Exeter, United Kingdom. Hauptthemen laut MEDLINE: Accelerometry, Wearable Electronic Devices. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 79 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The increasing use of accelerometers as digital health technologies in clinical trials and clinical care is driving the need for data processing to meet medical standards. The aim of this study was to create and test a modular pipeline for the pre-processing of high-resolution accelerometry that assures the quality, transparency and traceability of digital measures from sensor-level data. The objective is for the pipeline to be a foundational layer in the development, implementation and comparison of measures. The study developed the open GENEAcore package to meet the requirements of regulators, verifying the engineering implementation and analytically validating outputs against reference datasets. Early stages included the optimisation of calibration and non-wear detection. Data-driven detection of behavioural transitions was then validated to give direct bout outputs without the need to identify rules for epoch aggregation and interruptions. The utility for measure development was shown by comparing two algorithms for the characterisation of activity intensity in both the epoch and bout paradigms. Non-wear was detected with a balanced accuracy of 92.3% and the commonly used 13m g acceleration standard deviation threshold was empirically validated with a sensitivity analysis for the first time. The detection of transitions proved reliable with 99% detected, on average, within 2 seconds of their occurrence to give a mean expected event duration of 68.6s from a log-normal distribution. The different activity intensity algorithms were more than 99% concordant during movement but their outputs diverged in low movement conditions. Importantly, variable duration bouts created 31% higher daily activity durations compared to 1-second epochs. This evaluation of pre-processing steps has confirmed the attention to detail required to create robust and reproducible results for later clinical validation where small changes in an algorithm or its implementation may have clinically meaningful consequences.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

AccelerometryWearable Electronic DevicesHumansAlgorithmsDigital HealthReproducibility of ResultsCalibration

Autor:innen und Institutionen

  • Department of Public Health and Sport Sciences, University of Exeter, Exeter, United Kingdom.
  • ActivInsights Limited, Kimbolton, Cambridge, United Kingdom.
  • Stoat Group Limited, Devon, United Kingdom.

ORCID-Profile: Joss Langford

Zitieren

APA

Langford, J., Chua, J. Y., Long, I., Williams, A. C., & Hillsdon, M. (2026). Validation and optimisation of wearable accelerometer data pre-processing for digital measure implementation and development. PLOS One. https://doi.org/10.1371/journal.pone.0346458

Vancouver

Langford J, Chua JY, Long I, Williams AC, Hillsdon M. Validation and optimisation of wearable accelerometer data pre-processing for digital measure implementation and development. PLOS One. 2026. doi:10.1371/journal.pone.0346458

BibTeX
@article{Langford2026,
  author = {Langford, Joss and Chua, Jia Ying and Long, Ian and Williams, Alan C and Hillsdon, Melvyn},
  title = {Validation and optimisation of wearable accelerometer data pre-processing for digital measure implementation and development},
  journal = {PLOS One},
  year = {2026},
  doi = {10.1371/journal.pone.0346458}
}
Kostenlos starten →