EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Optimization of air supply mode of vehicle air conditioning based on digital thermal manikin

Hongmin Xu, Rui Wang, Fengge Ma, Jing Xuan, Chaoqing Feng iD

PLOS One · 2025

DOI: 10.1371/journal.pone.0339599 ↗

Kurz gefasst

Fachartikel in der Zeitschrift PLOS One, 2025. Verfasst von Hongmin Xu und 4 weiteren Autor:innen. Beteiligte Einrichtung: School of Energy and Power Engineering, Inner Mongolia University of Technology, Huhhot, China. Hauptthemen laut MEDLINE: Manikins, Air Conditioning, Automobiles. Die Arbeit nennt 29 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Key R&D Program of China, Special funds for the basic R&D undertakings by welfare research institutions, Inner Mongolia natural science funds.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

With the rapid development of the automobile industry, the public’s demand for automobile diversification is growing steadily.People are no longer satisfied with basic driving convenience, more attention is now directed to the thermal comfort of the cabin. In order to build the relationship between in-vehicle environment parameters and thermal comfort index, the concept of equivalent temperature (Teq) was introduced, and then the DTM reflecting the thermal comfort of the human body was applied to the simulation of ANSYS Fluent. For a specific working condition of the vehicle air conditioning, the equivalent temperature of the in-vehicle environment was tested by the DTM, and it was found that the highest Teq (approximately 27°C) was observed in the foot region of the passenger. The Teq of most areas of the passenger’s body was relatively low, especially in the temperature sensitive torso, it was about 15–20°C. Numerical calculations for the same working conditions were carried out using the DTM. By comparing the results of Teq between the DTM and the physical thermal manikin, it was found that the results are very similar, the Teq deviation was less than 3℃, indicating that DTM can be used to measure Teq instead of physical thermal manikin. Finally, the DTM model was used to optimize the air outlet of the vehicle air conditioning system. The results showed that the best comfort was achieved when the air velocity was 4 m/s, the outlet temperature was 25℃, and the airflow was directed toward the occupant’s abdomen.This study demonstrates that DTM can replace physical experiments in thermal comfort evaluation, providing an efficient and low-cost approach for optimizing vehicle HVAC design.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

ManikinsAir ConditioningAutomobilesHumansTemperature

Autor:innen und Institutionen

  • School of Energy and Power Engineering, Inner Mongolia University of Technology, Huhhot, China.
  • China National Institute of Standardization, Beijing, China.

ORCID-Profile: Chaoqing Feng

Förderung

  • National Key R&D Program of China
  • Special funds for the basic R&D undertakings by welfare research institutions
  • Inner Mongolia natural science funds
  • Inner Mongolia Youth Science and Technology Talent Project
  • Basic research funds for universities directly under Inner Mongolia
  • China Scholarship Council

Zitieren

APA

Xu, H., Wang, R., Ma, F., Xuan, J., & Feng, C. (2025). Optimization of air supply mode of vehicle air conditioning based on digital thermal manikin. PLOS One. https://doi.org/10.1371/journal.pone.0339599

Vancouver

Xu H, Wang R, Ma F, Xuan J, Feng C. Optimization of air supply mode of vehicle air conditioning based on digital thermal manikin. PLOS One. 2025. doi:10.1371/journal.pone.0339599

BibTeX
@article{Xu2025,
  author = {Xu, Hongmin and Wang, Rui and Ma, Fengge and Xuan, Jing and Feng, Chaoqing},
  title = {Optimization of air supply mode of vehicle air conditioning based on digital thermal manikin},
  journal = {PLOS One},
  year = {2025},
  doi = {10.1371/journal.pone.0339599}
}
Kostenlos starten →