EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Deposition of Sn-Zr-Se precursor by thermal evaporation and PLD for the synthesis of SnZrSe3 thin films

Rokas Kondrotas, Sergei Bereznev, Olga Volobujeva, Katri Muska, Vidas Pakštas, Vaclovas Klimas, Martynas Talaikis, Remigijus Juškėnas, Arūnas Krotkus

Materials Open Research · 14.02.2024 · 3 · 3

DOI: 10.12688/materialsopenres.17659.1 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Materials Open Research, online erschienen am 14.02.2024. Verfasst von Rokas Kondrotas und 8 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 45 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: HORIZON EUROPE Marie Sklodowska-Curie Actions, Estonian Research Council.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Background

ABX3 (X=Se, S) chalcogenides are an emerging class of materials for sustainable photovoltaics. Among ABX3 materials, BaZrS3 has gained the highest community interest. BaZrS3 is the wide bandgap absorber (> 1.7 eV) and therefore is intended for application as a top sub-cell in multijunction devices. However, narrow band gap ABX3 compounds have drawn little attention although this could potentially open the path for fabrication of multijunction solar cells based entirely on ABX3 materials. SnZrSe3 is a narrow bandgap semiconductor with an absorption edge located at around 1.0 eV, but there are no reports on the formation of SnZrSe3 thin films thus far. In this work, therefore, we aim to obtain SnZrSe3 thin films by sublimation methods.

Methods

Thermal evaporation and pulsed laser deposition (PLD) techniques were used to deposit Sn-Zr-Se precursor films. SnZrSe3 powder was synthesized and used as a source material for evaporation and PLD target preparation. Precursor films were deposited by PLD from single-phase and binary selenide targets.

Results

We found that using SnZrSe3 powder, only SnSe films were deposited under various conditions by thermal evaporation. Precursor films obtained by PLD from single-phase targets were amorphous and comprised SnSe2 and a-Se phases whereas using binary targets crystalline SnSe and a-Se were detected. Thermogravimetric analysis revealed that SnZrSe3 was thermally stable up to 450 °C and afterwards decomposed into SnSe, Se and ZrSe2-x.

Conclusions

Using methods described in this work, we were not able to achieve congruent sublimation of SnZrSe3 because of the following reasons: (i) upon energetic excitation, SnZrSe3 decomposes into compounds with very different vapour pressure; (ii) inability to substitute O with Se due to very high chemical affinity of Zr and O. Direct sublimation methods are challenging for formation of SnZrSe3 thin films and other techniques, such as co-evaporation should be explored.

Förderung

  • HORIZON EUROPE Marie Sklodowska-Curie Actions
  • Estonian Research Council

Zitieren

APA

Kondrotas, R., Bereznev, S., Volobujeva, O., Muska, K., Pakštas, V., Klimas, V., Talaikis, M., Juškėnas, R., & Krotkus, A. (2024). Deposition of Sn-Zr-Se precursor by thermal evaporation and PLD for the synthesis of SnZrSe3 thin films. Materials Open Research, 3, 3. https://doi.org/10.12688/materialsopenres.17659.1

Vancouver

Kondrotas R, Bereznev S, Volobujeva O, Muska K, Pakštas V, Klimas V, et al. Deposition of Sn-Zr-Se precursor by thermal evaporation and PLD for the synthesis of SnZrSe3 thin films. Materials Open Research. 2024;3:3. doi:10.12688/materialsopenres.17659.1

BibTeX
@article{Kondrotas2024,
  author = {Kondrotas, Rokas and Bereznev, Sergei and Volobujeva, Olga and Muska, Katri and Pakštas, Vidas and Klimas, Vaclovas and Talaikis, Martynas and Juškėnas, Remigijus and Krotkus, Arūnas},
  title = {Deposition of Sn-Zr-Se precursor by thermal evaporation and PLD for the synthesis of SnZrSe3 thin films},
  journal = {Materials Open Research},
  year = {2024},
  volume = {3},
  pages = {3},
  doi = {10.12688/materialsopenres.17659.1}
}
Kostenlos starten →