EUVIMEDEUVIMED entdecken
Crossref

Fabrication and characterization of polymethyl methacrylate microchannel using dry and underwater CO 2 laser

Mohamed O Helmy, Ahmed R Fath El-Bab, Hassan A El-Hofy

Proceedings of the Institution of Mechanical Engineers, Part N: Journal of Nanomaterials, Nanoengineering and Nanosystems · 2018-03 · 232 (1) · 23-30

DOI: 10.1177/2397791417749700 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Proceedings of the Institution of Mechanical Engineers, Part N: Journal of Nanomaterials, Nanoengineering and Nanosystems, online erschienen am 01.01.2018. Verfasst von Mohamed O Helmy und 2 weiteren Autor:innen. Die Arbeit wurde bisher 13-mal zitiert (Crossref) und nennt 22 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Over the last few decades, miniaturization has become the key aspect of driving evolution of modern technology. The CO 2 laser is an inexpensive, flexible, and fast device for fabricating microfluidic chips. Thermal damages associated with such a process are considered the big challenge for microfluidic device developers. This article evaluates the quality of polymethyl methacrylate microchannels fabricated by the CO 2 laser. Experiments were conducted in the air (dry) and underwater by leaving a thin water layer on the top surface of the polymethyl methacrylate substrate. The effect of laser power and scanning speed on performance characteristics, such as the microchannel aspect ratio, surface roughness, and heat-affected zone was studied. Taguchi’s experimental design with grey relational analysis was used for multi-objective optimization of the laser micromachining parameters. Analysis of variance was also employed to determine the most significant control factors that affect the microchannel quality. The results indicated that the cooling effect of the underwater method has a significant effect on decreasing the extent of thermal damage while increasing the aspect ratio. Laser power is the most significant factor on the performance characteristics followed by scanning speed and pulse rate. Grey relational analysis is efficient in selecting the optimum conditions regarding the performance characteristics.

Zitieren

APA

Helmy, M. O., El-Bab, A. R. F., & El-Hofy, H. A. (2018). Fabrication and characterization of polymethyl methacrylate microchannel using dry and underwater CO 2 laser. Proceedings of the Institution of Mechanical Engineers, Part N: Journal of Nanomaterials, Nanoengineering and Nanosystems, 232(1), 23-30. https://doi.org/10.1177/2397791417749700

Vancouver

Helmy MO, El-Bab ARF, El-Hofy HA. Fabrication and characterization of polymethyl methacrylate microchannel using dry and underwater CO 2 laser. Proceedings of the Institution of Mechanical Engineers, Part N: Journal of Nanomaterials, Nanoengineering and Nanosystems. 2018;232(1):23-30. doi:10.1177/2397791417749700

BibTeX
@article{Helmy2018,
  author = {Helmy, Mohamed O and El-Bab, Ahmed R Fath and El-Hofy, Hassan A},
  title = {Fabrication and characterization of polymethyl methacrylate microchannel using dry and underwater CO 2 laser},
  journal = {Proceedings of the Institution of Mechanical Engineers, Part N: Journal of Nanomaterials, Nanoengineering and Nanosystems},
  year = {2018},
  volume = {232},
  number = {1},
  pages = {23--30},
  doi = {10.1177/2397791417749700}
}
Kostenlos starten →