Optimization of the full-load combustion schemes of n-butanol/biodiesel reactivity-controlled compression ignition (RCCI) toward high-efficiency and low-emission engines
International Journal of Engine Research · 2025-04 · 26 (4) · 472-497
DOI: 10.1177/14680874241278960 ↗Kurz gefasst
Fachartikel in der Zeitschrift International Journal of Engine Research, online erschienen am 08.10.2024. Verfasst von Yikang Cai und 6 weiteren Autor:innen. Die Arbeit wurde bisher 5-mal zitiert (Crossref) und nennt 59 Literaturangaben. Gefördert von: National Natural Science Foundation of China, Dalian Key Science and Technology Research and Development Program, National Key Research and Development Program of China.
Abstract (Originalsprache)
Biodiesel and n-butanol, as popular alternative fuels, can be used in advanced reactivity-controlled compression ignition (RCCI) engines for efficient and clean combustion. However, the complex interactions between n-butanol and biodiesel, as well as the best combustion schemes at different loads, remain poorly understood. Given this, the objective of this paper is to identify optimal fuel organizations for n-butanol/biodiesel RCCI engines across different load scenarios by combining engine simulation with a global optimization algorithm, explore the potential synergies of control parameters, and analyze microscopic dual-fuel interactions based on the integrated average reaction path analysis. Results show that the optimal scheme at low load employs almost homogeneous fuel-air mixtures at elevated temperature atmosphere above 390 K, with n-butanol energy share exceeding 96% and optimal biodiesel injection timing between −70 and −50 °CA. Higher n-butanol ratio coupled with increased intake temperature improves engine performance. For mid load, biodiesel injection timing is retarded to −55 to −30 °CA, and biodiesel proportion is increased to introduce reactivity stratification, while maintaining its energy share below 20% to mitigate NO x emissions. Notably, biodiesel density is identified as the primary physical property influencing NO x formation. At high load, a split combustion scheme involving premixing and subsequent diffusion combustion is optimal. The physical effects of n-butanol addition minimally impact the low-temperature ignition of biodiesel, while its chemical effects significantly defer the low-temperature reactivity. The reaction path analysis reveals that n-butanol competes with biodiesel for OH radical consumption, with a large proportion of OH and HO 2 consumed in the cyclic reactions of nC 4 H 9 OH and nC 4 H 8 OH. Adjusting the reactivity stratification affects the reaction state of n-butanol entrained by the biodiesel jets. Higher reactivity gradient intensifies biodiesel reactions to induce the pyrolysis of the involved n-butanol through nC 4 H 8 OH => 2C 2 H 4 + OH, therefore resulting in more staged heat release.
Förderung
- National Natural Science Foundation of China
- Dalian Key Science and Technology Research and Development Program
- National Key Research and Development Program of China
Zitieren
APA
Cai, Y., Jia, M., Li, Y., Li, H., Liu, Z., Ding, R., & Lu, X. (2025). Optimization of the full-load combustion schemes of n-butanol/biodiesel reactivity-controlled compression ignition (RCCI) toward high-efficiency and low-emission engines. International Journal of Engine Research, 26(4), 472-497. https://doi.org/10.1177/14680874241278960
Vancouver
Cai Y, Jia M, Li Y, Li H, Liu Z, Ding R, et al. Optimization of the full-load combustion schemes of n-butanol/biodiesel reactivity-controlled compression ignition (RCCI) toward high-efficiency and low-emission engines. International Journal of Engine Research. 2025;26(4):472-497. doi:10.1177/14680874241278960
BibTeX
@article{Cai2025,
author = {Cai, Yikang and Jia, Ming and Li, Yaopeng and Li, Haoran and Liu, Zihe and Ding, Rui and Lu, Xingcai},
title = {Optimization of the full-load combustion schemes of n-butanol/biodiesel reactivity-controlled compression ignition (RCCI) toward high-efficiency and low-emission engines},
journal = {International Journal of Engine Research},
year = {2025},
volume = {26},
number = {4},
pages = {472--497},
doi = {10.1177/14680874241278960}
}
EUVIMED