Characterisation of the mechanical performance of a novel thermoplastic film adhesive
Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications · 17.08.2026
DOI: 10.1177/14644207261467393 ↗Kurz gefasst
Fachartikel in der Zeitschrift Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications, online erschienen am 17.08.2026. Verfasst von Ana T.F. Venâncio und 7 weiteren Autor:innen. Die Arbeit nennt 61 Literaturangaben.
Abstract (Originalsprache)
This study presents a comprehensive mechanical characterisation of a novel, transparent, amorphous thermoplastic hot-melt adhesive (HMA) film, based on a cyclo olefin polymer, engineered for applications in the automotive, electronics and semi-structural bonding sectors. Quasi-static tensile tests reveal typical thermoplastic behaviour, cold drawing followed by strain hardening, with a Young's modulus of 230 MPa, a tensile strength of 11 MPa and an exceptional elongation at break of 1000%. Thick adherend shear tests (TAST) yield a shear strength of 5 MPa. Fracture behaviour was investigated under Mode I and Mode II loading. Double cantilever beam (DCB) tests on CFRP substrates provide an apparent Mode I fracture energy of 0.43 N/mm. Despite minor substrate rotation and stretching effects, the results indicate a predominantly ductile response of the adhesive layer. End-notched flexure (ENF) tests reveal more complex Mode II behaviour: an initial peak fracture energy of 2.6 N/mm is obtained after a sustained plateau near 0.5 N/mm, interpreted as the onset of permanent plastic damage. This plateau, uncommon in comparable thermoplastic adhesives, suggests a progressive transition from brittle to ductile failure and consistently coincides with adhesive failure at the interface. Dynamic mechanical analysis (DMA) identifies a glass transition temperature of 88°C. Collectively, these results demonstrate that the material offers strong potential for applications requiring thermal resistance and pressure-tolerant bonding, though enhancements in interfacial adhesion are needed to fully optimize performance.
Zitieren
APA
Venâncio, A. T., Rodrigues, V. C., Marques, E. A., Carbas, R. J., Uam, J., Kazuhiro, E., Nelson, B., & Silva, L. F. D. (2026). Characterisation of the mechanical performance of a novel thermoplastic film adhesive. Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications. https://doi.org/10.1177/14644207261467393
Vancouver
Venâncio AT, Rodrigues VC, Marques EA, Carbas RJ, Uam J, Kazuhiro E, et al. Characterisation of the mechanical performance of a novel thermoplastic film adhesive. Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications. 2026. doi:10.1177/14644207261467393
BibTeX
@article{Venncio2026,
author = {Venâncio, Ana T.F. and Rodrigues, Vasco C.M.B. and Marques, Eduardo A.S. and Carbas, Ricardo J.C. and Uam, Ju-Young and Kazuhiro, Ejiri and Nelson, Björn and Silva, Lucas F.M. da},
title = {Characterisation of the mechanical performance of a novel thermoplastic film adhesive},
journal = {Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications},
year = {2026},
doi = {10.1177/14644207261467393}
}
EUVIMED