Fabrication of nanoindentation array-based SERS substrate using Conical and Berkovich indenters
Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science · 2023-10 · 237 (20) · 4713-4725
DOI: 10.1177/09544062231153817 ↗Kurz gefasst
Fachartikel in der Zeitschrift Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, online erschienen am 08.02.2023. Verfasst von Yanquan Geng und 3 weiteren Autor:innen. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 28 Literaturangaben. Gefördert von: Natural Science Foundation of China, Young Elite Scientist Sponsorship Program by CAST, Science and Technology Based for Equipment Design and Manufacturing for Introduction Talents of Discipline to Universities 2.0 of the 111 project.
Abstract (Originalsprache)
This paper reports a study of the effect of indenter geometry on the morphologies of the indentation arrays using a home-made nanoindentation system. Two typical indenters, that is, Conical and Berkovich indenters are chosen to conduct all the indentation process on a pure aluminum block surface. Single-row and multiple-row indentation arrays are machined, and the effect of the spacing value between the adjacent indentations with different indenters are studied in detail. Results show that the overlapping of the indentations and the material filling by the following penetration are the two main factors of the surface topography quality of the obtained structures. The smaller the spacing value is, the larger the indentation deformation is, and the worse the quality of the periodic structure is. In addition, the surface enhanced Raman scattering (SERS) substrates are prepared by the machined indentation arrays, and the SERS spectra is measured using Rhodamine 6G (R6G). The results show that a higher Raman enhancement factor is obtained on the Conical indentation arrays, which is attributed to the higher depth-to-width ratio of the indentation array. Therefore, this work can provide a guidance for the preparation of SERS substrate with suitable indenter geometries and the indentation interval values.
Förderung
- Natural Science Foundation of China
- Young Elite Scientist Sponsorship Program by CAST
- Science and Technology Based for Equipment Design and Manufacturing for Introduction Talents of Discipline to Universities 2.0 of the 111 project
- Fundamental Research Funds for the Central Universities
Zitieren
APA
Geng, Y., Wang, J., Yan, Y., & Cai, J. (2023). Fabrication of nanoindentation array-based SERS substrate using Conical and Berkovich indenters. Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 237(20), 4713-4725. https://doi.org/10.1177/09544062231153817
Vancouver
Geng Y, Wang J, Yan Y, Cai J. Fabrication of nanoindentation array-based SERS substrate using Conical and Berkovich indenters. Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science. 2023;237(20):4713-4725. doi:10.1177/09544062231153817
BibTeX
@article{Geng2023,
author = {Geng, Yanquan and Wang, Jiqiang and Yan, Yongda and Cai, Jianxiong},
title = {Fabrication of nanoindentation array-based SERS substrate using Conical and Berkovich indenters},
journal = {Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science},
year = {2023},
volume = {237},
number = {20},
pages = {4713--4725},
doi = {10.1177/09544062231153817}
}
EUVIMED