EUVIMEDEUVIMED entdecken
Crossref

Effect of build orientation on tribological and flexural properties of FDM-printed composite PLA parts

Paşa Yaman, Olcay Ekşi, Sencer Süreyya Karabeyoğlu, Kamil Feratoğlu

Journal of Reinforced Plastics and Composites · 2024-01 · 43 (1-2) · 97-110

DOI: 10.1177/07316844231157790 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Reinforced Plastics and Composites, online erschienen am 14.02.2023. Verfasst von Paşa Yaman und 3 weiteren Autor:innen. Die Arbeit wurde bisher 28-mal zitiert (Crossref) und nennt 56 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In the study, parts are fused deposition modeling–printed using polylactic acid filaments filled with copper, brass, bronze, tungsten, and carbon fiber. Wear and three-point bending tests are applied to FDM-printed specimens and it is yielded that on-edge oriented specimens had higher flexural strength while flat orientation contributed to wear resistance. Wear tracks are examined, and mostly abrasive wear is detected in the dry sliding condition while adhesive, fatigue and abrasive wear is observed in the wet sliding condition. Brass-filled polylactic acid specimens showed highest flexural strength and flexural modulus with 46.73 MPa and 1.53 GPa, respectively. Besides, the most wear resistant filler is determined as tungsten for dry and wet sliding conditions.

Zitieren

APA

Yaman, P., Ekşi, O., Karabeyoğlu, S. S., & Feratoğlu, K. (2024). Effect of build orientation on tribological and flexural properties of FDM-printed composite PLA parts. Journal of Reinforced Plastics and Composites, 43(1-2), 97-110. https://doi.org/10.1177/07316844231157790

Vancouver

Yaman P, Ekşi O, Karabeyoğlu SS, Feratoğlu K. Effect of build orientation on tribological and flexural properties of FDM-printed composite PLA parts. Journal of Reinforced Plastics and Composites. 2024;43(1-2):97-110. doi:10.1177/07316844231157790

BibTeX
@article{Yaman2024,
  author = {Yaman, Paşa and Ekşi, Olcay and Karabeyoğlu, Sencer Süreyya and Feratoğlu, Kamil},
  title = {Effect of build orientation on tribological and flexural properties of FDM-printed composite PLA parts},
  journal = {Journal of Reinforced Plastics and Composites},
  year = {2024},
  volume = {43},
  number = {1-2},
  pages = {97--110},
  doi = {10.1177/07316844231157790}
}
Kostenlos starten →