EUVIMEDEUVIMED entdecken
Crossref

Experimental and statistical investigation of the effect of input parameters on output parameters in laser cutting of stainless steel material

Engin Nas, Barış Özlü

Ironmaking & Steelmaking: Processes, Products and Applications · 2026-11 · 53 (9) · 2038-2053

DOI: 10.1177/03019233251349871 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Ironmaking & Steelmaking: Processes, Products and Applications, online erschienen am 17.06.2025. Verfasst von Engin Nas und 1 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 51 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study experimentally and statistically investigated the effects of machining parameters on surface roughness and upper and lower kerf widths during the laser cutting of AISI 304 stainless steel. The experimental design was based on the L18 orthogonal array of the Taguchi technique. Laser cutting parameters included focal point (−4 mm and 4 mm), gas pressure (5, 10, and 15 bar), and cutting speed (5000, 7500, and 10,000 mm/min). The results showed that cutting speed and gas pressure reduced surface roughness up to a critical threshold. Additionally, increasing cutting speed decreased kerf widths, while higher gas pressure led to increased upper and lower kerf widths. Statistical analysis identified cutting speed as the most influential parameter for surface roughness (56.05%), upper kerf width (35.33%), and lower kerf width (66.33%). Finally, the Taguchi-based Grey relational analysis determined the optimal machining parameters as A 2 B 1 C 3 .

Zitieren

APA

Nas, E., & Özlü, B. (2026). Experimental and statistical investigation of the effect of input parameters on output parameters in laser cutting of stainless steel material. Ironmaking & Steelmaking: Processes, Products and Applications, 53(9), 2038-2053. https://doi.org/10.1177/03019233251349871

Vancouver

Nas E, Özlü B. Experimental and statistical investigation of the effect of input parameters on output parameters in laser cutting of stainless steel material. Ironmaking & Steelmaking: Processes, Products and Applications. 2026;53(9):2038-2053. doi:10.1177/03019233251349871

BibTeX
@article{Nas2026,
  author = {Nas, Engin and Özlü, Barış},
  title = {Experimental and statistical investigation of the effect of input parameters on output parameters in laser cutting of stainless steel material},
  journal = {Ironmaking & Steelmaking: Processes, Products and Applications},
  year = {2026},
  volume = {53},
  number = {9},
  pages = {2038--2053},
  doi = {10.1177/03019233251349871}
}
Kostenlos starten →